Site work for a water / sewer project in Milwaukie, Oregon. Completed plans call for site work for a water / sewer project.

The Oregon Liquor Control Commission (OLCC) is soliciting quotes for PIV repairs located at its headquarters office. Control Number: 2042827 Locating is required prior to dig. New Electronic monitoring weatherproofswitches will be installed on each PIV 4 total Vaults will be placed for all locations next to the fire alarm suppression locations. 1" conduit will be used in ground along with Direct Burial (DB) cable Bore #1; Contractor will bore approximately 60' in front of the building's entrance. The bore path will be from the fire alarm suppression location to the electrical PVC cover. Contractor will place 1" conduit in the bore path. The conduit will be mounted to the exterior wall of the building, to the height of the interior false ceiling. At this point, contractor will core drill a 1 V4" access hole and will insert a sleeve. The hole will be sealed per code, contractor will install finishing ring to both interior and exterior penetrations to cover installation and sealant. All fire cable shall be installed in the underground conduit, connected at each PIV valve, and interior wiring installed to the fire alarm control panel head end, circuit trim out and test for function. Bore #2 East Side; The bore path will be from the fire alarm suppression location on the north end. This bore bath will placed approximately 300' south and will go 90-degree over to the warehouse. The conduit will be mounted on the exterior wall ofthe warehouse to the point where the contractor will core drill an access hole to enter the building. Contractor will core drill a 1 V4" access hole and will insert a sleeve. The hole will be sealed per code, contractor will install finishing ring to both interior and exterior penetrations to cover installation and sealant. All fire cable shall be installed in the underground conduit, connected at each PIV valve, and interior wiring installed to the fire alarm control panel head end, circuit trim out and test for function. Interior Wire: 16/4, SOL or STD, FPL, White or Red non-shielded Genesis cable ADI# WG-41125001 or equivalent shall be used Exterior wire: 16/4 SOL or STD, FPL, DB, Black West Penn Wire ADI# WP-AQ245 or equivalent shall be used.