Demolition, site work, new construction, renovation and addition to a municipal facility in Buffalo, New York. Completed plans call for the addition of a municipal facility; for the demolition of a municipal facility; for the construction of a municipal facility; for the renovation of a municipal facility; and for site work for a municipal facility.

The project objective is to replace worn-out sections of overhead contact wires and insulators on the Overhead Contact System (OCS) for the Light Rail Rapid Transit system in Buffalo, NY. There are four (4) work areas located in the Tunnel. The total length of the work areas for both the inbound and outbound Catenary is 14,135 linear feet. The Work of this project provides for the furnishing of all labor, materials, appliances, tools, equipment and plant, and the performing of all Work in accordance to the specifications and drawings, with exception of work that is expressly and specifically not included in the project. The project consists of one (1) contract. The BASE BID work shall include, but not be limited to the following in Work: Replace contact wire(s) and remove redundant material Replace all support insulators and refurbish all OCS equipment in the areas identified above including any section insulators at the Work Limits. All OCS installations shall be configured to clear the vehicle and pantograph dynamic envelope. The OCS installation shall meet the requirements specified herein and specified elsewhere on the Contract Documents. As-built documentation. New York State certified minority owned business enterprises ("MBE") participation is 0%. New York State certified women owned business enterprises ("WBE") participation is 0%. New York State certified Service-Disabled Veteran-Owned Business (SDVOB) is 0%. Work by Others shall include, but not be limited to: Existing section insulators runners will be refurbished, installed and set by the NFTA. Existing cranked and flat brackets used in OCS supports are to be refurbished by NFTA. Authority furnished materials shall include: New contact wire New insulators for Type A and Type B tunnel supports. New parts for Type A and Type B tunnel supports if needed to replace worn parts. New spool insulators for installation in tunnel supports, terminations, mid-point anchors, etc. Contractor shall supply all equipment, labor, hardware and other materials needed for installation of NFTA supplied materials. Service-Disabled Veteran-Owned Set Aside: No Minority Owned Sub-Contracting Goal: 0% Women Owned Sub-Contracting Goal: 0% Service-Disabled Veteran-Owned Business Contracting Goal: 0% The Contract Documents may be picked up Monday through Friday from 8 a.m. to Noon and 1:00 p.m. to 3:30 p.m., or sent via courier billed to the requester.