Demolition, site work, paving and new construction of a mixed-use development in Eatonville, Florida. Completed plans call for the demolition of a municipal facility; for the construction of a municipal facility; for site work for a municipal facility; for paving for a municipal facility; road / highway; road / highway; sidewalk / parking lot; sidewalk / parking lot; and water / sewer project.

For the construction of the Park Master Lift Station Replacement Project The Project consists of decommissioning and demolishing the existing lift station, disconnecting and relocating the existing on-site diesel generator to police station, constructing a new master lift station, including but not limited to, installation of a 10-foot diameter wet well, two (2) submersible 25-HP pumps and appurtenances, concrete valve vault with associated valves and piping, 14-foot wide concrete driveway, mag meter and concrete vault, associated electrical improvements, and road and site restoration. Bids will be received for a single prime Contract. Bids shall be on a lump sum basis, as indicated in the Bid Form. Upon Issuing Office receipt of payment, printed Bidding Documents will be sent via the prospective Bidder's delivery method of choice; the shipping charge will depend on the shipping method chosen. The date that the Bidding Documents are transmitted by the Issuing Office will be considered the prospective Bidder's date of receipt of the Bidding Documents. Partial sets of Bidding Documents will not be available from the Issuing Office. Neither Owner nor Engineer will be responsible for full or partial sets of Bidding Documents, including Addenda if any, obtained from sources other than the Issuing Office. Bid security shall be furnished in accordance with the Instructions to Bidders. Section 746 of Title VII of the Consolidated Appropriations Act of 2017 (Division A - Agriculture, Rural Development, Food and Drug Administration, and Related Agencies Appropriations Act, 2017) and subsequent statues mandating domestic preference applies an American Iron and Steel requirement to this project. All listed iron and steel products used in this project must be produced in the United States. The term "iron and steel products" means the following products made primarily of iron or steel: lined or unlined pipes and fittings, manhole covers, and other municipal castings, hydrants, tanks, flanges, pipe clamps and restraints, valves, structural steel. reinforced precast concrete, and construction materials. The deminimis and minor components waiver apply to this contract.