Site work and renovation of a civil project in Orland Hills, Illinois. Completed plans call for the renovation of a water / sewer project; and for site work for a water / sewer project.

160373.00008 The types of Work to be performed include but are not limited to the following: A. Furnish and install control building including: Main Circuit Breaker Automatic Transfer Switch (ATS) Motor Control Center (MCC) Soft Start Reduced Voltage Starters (SSRVS) Pump Control Panel and SCADA System Electrical Distribution Panels B. Furnish and install submersible type wastewater pumps in existing wet well. C. Furnish and install ductile iron (DI) discharge piping, fittings, check valves and plug valves in existing valve vault. D. Existing concrete structure restoration and waterproofing. E. Furnish and install diesel engine standby generator. F. Furnish and install flow meter in vault. G. Electric service coordination and installation. H. Bypass pumping. I. Site restoration. Alternate #1 J. Furnish and install underground storage system, sanitary sewer, groundwater underdrain and pump station. Alternate #2 K. Furnish and install sluice gate and electric motor actuator at existing wet well. A bid bond, certified check/bank draft on a solvent bank, payable without condition to the Village of Tinley Park in an amount not less than ten percent (10%) of the bid shall be submitted with each proposal, as a guarantee that, if the proposal is accepted, a contract will be entered into, and the performance of the contract is properly secured. A performance bond in a sum equal to one hundred percent (100% of the amount of the bid), with sureties to be approved by the Mayor and Board of Trustees for the faithful performance of the contract must be furnished by the successful bidder. All bids or proposals shall contain an offer to furnish bond upon acceptance of such bid or proposal. The contractor shall also comply with all applicable federal, state, and local regulations. The Village of Tinley Park, Local Vendor Purchasing Policy provides local vendors with preferential treatment when competing for contracts with the Village. A local vendor is defined as a business that has an actual business location within the Village of Tinley Park and is licensed by the Village. As such when considering contracts, the Village of Tinley Park reserves the right to forego the lowest and responsible bid in favor of a local vendor under the following circumstances: Contract Value Range (up to a maximum of) $0-$250,000 5% $250,000-$500,000 4% $500,000-$750,000 3% $750,000-$1,000,000 2% $1,000,000-$2,000,000 1% Responsible bidders are determined pursuant to the criteria set forth pursuant to the criteria set forth in the Village's Responsible Bidder Ordinance No. 2019-O-079. Bidder qualifications and experience will also be included in the basis for determining the lowest responsible bidder. The right is reserved to reject any or all bids, to waive technicalities, to postpone the bid opening, or to advertise for new proposals, if in the judgment of the Mayor and Board of Trustees their best interests will be promoted thereby. THIS WORK SHALL CONSIST OF FURNISHING ALL MATERIALS, EQUIPMENT AND SERVICES NECESSARY FOR THE CONSTRUCTION, INSTALLATION AND TESTING OF A CONTROL BUILDING FOR AUTOMATIC TRANSFER SWITCH (ATS), MAIN CIRCUIT BREAKER, MOTOR CONTROL CENTER (MCC), SOFT START REDUCED VOLTAGE STARTERS (SSRVS), PUMP CONTROL PANEL AND SCADA SYSTEM, AND ASSOCIATED ELECTRICAL DISTRIBUTION PANELS; SUBMERSIBLE TYPE WASTEWATER PUMPS IN EXISITNG WET WELL; DUCTILE IRON (DI) DISCHARGE PIPING, FITTINGS, CHECK VALVES AND PLUG VALVES IN EXISTING VALVE VAULT; FLOW METER IN VAULT; EXISTING CONCRETE STRUCTURE RESTORATION AND WATERPROOFING; DIESEL ENGINE STANDBY GENERATOR; ELECTRIC SERVICE INSTALLATION; BYPASS PUMPING; SITE RESTORATION