The purpose of this solicitation is to solicit competitive sealed submittals to furnish PUBLIC TRANSPORTATION GATE SYSTEM (RE-BID) for Lake County, Florida Vendors must examine all solicitation documents including the General Terms and Conditions for Lake County Florida. All communication, inquiries, or requests for exceptions are to be directed to the Contracting Officer listed in Section 2.0. The last day for questions or requests for exceptions is 02/04/2022. An addendum may be issued in response to any inquiry received, which changes or clarifies the terms, provisions, or requirements of the solicitation. No answers given in response to questions submitted will be binding upon this solicitation unless released in writing as an addendum to the solicitation and posted on the Formal Solicitations site (lakecountyfl.gov) for this solicitation. Where there appears to be a conflict between this solicitation and any addenda, the last addendum issued will prevail. The County owns and retains all proprietary rights in its logos, trademarks, trade names, and copyrighted images (Intellectual Property). Nothing in this solicitation permits or shall be construed as authorization to use or display County's Intellectual Property on Respondent's submittal documents or proposal (including any exhibits attached thereto) in response to this solicitation. Unless expressly authorized in writing by County, a Respondent is not authorized and shall not make use of or display any County Intellectual Property on or in its proposal or submittals. Unauthorized use of County's Intellectual Property may constitute trademark and copyright infringement in violation of federal and state laws. It is a violation of Lake County Code Section 2-1 and deemed a second-degree misdemeanor under Florida Statutes Section 165.043. Remove and dispose of existing sliding gate. 2.1.2. Furnish and install the following 1. One (1) Galvanized chain link cantilever slide gate with heavy duty commercial rollers. 2. One (1) Hy-security 222 gate operator with mounting deck 3. One (1) Set of photo eyes 4. One (1) Safety edge 5. One (1) Entry loop detector 6. One (1) Free exit loop 7. One (1) Click2Enter controlled access device for fire/police access. 8. One (1) Direct burial heavy duty gooseneck pedestal with (1) RBH access control proximity reader located at the exterior of the gate at least six (6) feet away from the gate operator. Height and location to be selected by Public Transportation. 9. Two (2) Warning placards; one (1) placed on each side of the gate. 2.1.3 Provide electrical and network services including all material, labor, equipment, asphalt repair, and permits needed for the RBH access-controlled sliding gate to be complete and fully functioning.
.webp)
