Construct a temporary construction entrance. Drain the pond by pumping water into the reservoir downstream of the spillway. Continue to pump water, as needed, for the duration of the project. Remove the rock from the perimeter of the pond. Some portion of existing rock may be considered for reuse if well graded, clean, and satisfactorily similar to new rock. Remove the existing liner. Install/construct temporary concrete spillway inlet protection. Repair or construct built up soil curb around the perimeter of the pond in approximately the same location as the existing. Excavate the anchor shelf and anchor trench. Install 10 OZ. Non-woven geotextile liner. Install 40 mil HDPE geomembrane liner. Install No. 2 stone from the anchor trench to the built up curb around the entire perimeter of the pond. Install low mobility grout at the base of intake pipe support. Ensure seal of existing intake by installing HDPE pipe boot. Remove the spillway inlet protection. Stabilize all disturbed areas around the pond. Remove the construction entrance and stabilize the area. Estimated Length of Project: 60 (Substantial Completion) + 15 (Final Completion) No bidder may withdraw his bid for a period of thirty (30) days after the date set for the opening of bids. The Division of Engineering and Contract Administration, Commonwealth of Kentucky, reserves the right to reject any and all bids and to waive all informalities and/or technicalities where the best interest of the Commonwealth may be served. All bids shall be accompanied by a bid guarantee (in the form of a bid bond or certified check) of not less than five (5%) percent of the amount of the lump sum base bid. A 100% Performance Bond and a separate 100% Payment Bond shall be furnished by the successful bidder. All bonding and insurance requirements are contained in the Instructions to Bidders and/or General Conditions. Bonds should be executed by a surety company authorized to do business in the Commonwealth of Kentucky
.webp)
