Purchase and Installation 24ft L x 30ft W x 12ft H Prefabricated Metal Building (Pole Barn) Question Submission Deadline: June 28, 2023, 4:00pm The City of Lake City reserves the right to accept or reject any/all bids and to award the contract in the best interest of the City of Lake City, Florida.
General Scope of Work
1.The contractor shall purchase and install one (1) new pre-fabricated metal building (pole barn) with
roof. Shop drawings shall be provided and approved by the City of Lake City before manufacturing
begins. The storage building shall comply with all State, Federal, and local laws and ordinances.
2.The building system shall include but not limited to: structural steel system, metal roof system, and all
trim and accessories as required and foundation design and installation.
3. The intended use of this building is to act as a cover or awning over equipment, trailers, and vehicles
to limit their exposure to the elements.
4. The successful Contractor shall be responsible for providing all required engineered drawings and
specifications required to obtain the appropriate building permits. Electrical improvements will not be
needed.
3.2. Specifications
1.The size of building shall be 24ft in Length x 30ft in Width x 12ft in Height.
2.The building must have an eave height in the back side of 11.5ft and front side of 12ft clearance with a
2ft overhang on all sides with no Soffits. The building will be attached to an existing building with
flashing to prevent rain from passing between them.
3.Two (2) single slope ridge frames, clear span.
4. No electricity is needed to the building.
5. The building shall be designed and constructed to meet International Building Code (IBC) 15 and a
minimum wind load of 120 mph. Building shall meet current Florida Building Codes.
6.Roof and side walls shall be 26 Gauge Galvalume Plus. Trim for the Wall, Roof, and Jamb shall be
Galvalume Plus. No insulation is required for roof or walls.
7.No slab is required; only foundations/footings shall be installed as required for the support framing.
8.All screw must contain an integral rubber washer.
9.The roof pitch shall be designed as single slope with no gutters and downspouts ensuring any runoff
are directed away from the building. Roof metal shall be a minimum 26 gauge metal.
10.Roof and Trim color will be chosen once bidder has been selected and the steel structure will be
standard red iron color.
11. Concrete footers are the responsibility of the Contractor.
12.Freight charges must be included in the proposal. Delivery will be to the City of Lake City Saint
Margarets Waste Water Treatment Plant located at 527 SW Saint Margarets Street, Lake City, FL 32025.
.webp)
