Demolition for a municipal facility in Smyrna, Tennessee. Completed plans call for the demolition of a municipal facility.

The Work shall consist of the disassembly of the existing building for storage on-site at the Smyrna VTS, K span building, see below. Existing concrete slab shall remain. Contractor shall be responsible for all means, materials, sequences and techniques of the Work. NOTE: No electrical service is available in the building. Any prospective Respondent having questions and comments concerning this ITB must provide them in writing to the Solicitation Coordinator. All questions must be submitted no later than September 1, 2023 at 10:00 AM CDT. SUBJECT BUILDING DETAILS: Schulte Building Systems Pre-Engineered Metal Building (erected 2009) Nominal Dimensions: Length 45'-0" / Length 160'-0" / Height 24'-0" / Slope 3:12 Location: Smyrna Volunteer Training Site 4th Street and H Street Smyrna, TN 37167 Storage Site: Building and Lay Down Yard G Street Smyrna, TN 37167 Contact: Derek Hunt 615-961-1732 SEE PHOTOS ON FOLLOWING PAGE GENERAL SCOPE OF WORK: The Work shall consist of the disassembly of the existing building for storage on-site at the Smyrna VTS, K span building, see below. Existing concrete slab shall remain. Contractor shall be responsible for all means, materials, sequences and techniques of the Work. NOTE: No electrical service is available in the building. SPECIFIC SCOPE OF WORK: 1. All materials are to be inconspicuously marked prior to disassembly to facilitate reassembly. Supplemental photo and noted drawing documentation to facilitate reassembly is required. 2. Contractor shall exercise reasonable care to prevent surface damage to all components. 3. All fasteners, screws, bolts, cables, wires, connection points and the like are to be reinserted where necessary to facilitate to reassembly. 4. All materials shall be reasonably clean and dry prior to nesting and stacking. 5. Like components are to be nested, stacked, bundled and/or palletized where possible. 6. Remove (8) 3'-4" wide x 7'-2" tall hollow metal doors and frames. Remove doors and frames as one assembly. 7. Remove (2) 20'-0" wide x 16'-)' tall overhead coiling doors. Remove doors and operators as one assembly. 8. Remove (2) gutters and (8) downspouts. 9. Remove corrugated metal wall panels and trim (nominally 24" wide x 24' tall). 10. Disconnect actuators of (4) 12" x 10'-0" ridge vents and remove actuators and vents. 11. Remove (12) 12" x 10'-8" skylight panels. 12. Remove roof panels. 13. Remove all wall vinyl-faced batt wall insulation. Contractor shall use reasonable efforts to maintain the integrity of the batts and roll the same for storage. 14. Disassemble all remaining columns, rafters, purlins, girts and other structural steel components to their minimum lengths where possible.