Renovation of a water / sewer project in Wilmette, Illinois. Completed plans call for the renovation of a water pump station.

Remove remnants of the original air pump, supports, piping, power, and controls installed in 1938 or later. 2. Remove existing centrifugal pump and install two new submersible centrifugal pumps in the dry-well to improve performance and reliability of the lift station. Pumps shall automatically alternate running for equal wear. Duplex arrangement will allow maintenance of individual pumps in the system without shutting down the entire system. 3. Remove and replace 8" and 10" dia. cast iron discharge pipes, install thermal insulation and heat-tracing on new exterior pipes. 4. Remove and replace existing sump pump and discharge pipes. 5. Remove grating located inside station at elevation +3.37. 6. Install new pipes, fittings, and valves as shown on drawings. 7. Install equipment pads and supports for new pumps and piping. 8. Install an upgraded electrical system for pumps powering and lighting. 9. Provide controls to monitor submersible pumps. All controls shall be integrated through the terminal inside the Wilmette Pumping Station into the DCS center situated at O'Brien Water Reclamation Plant (WRP). 10. Provide DCS programming and graphics. 11. Restore existing grading and landscaping as needed to ensure proper drainage and aesthetics. 12. Perform other work as specified in the Detail Specifications and as shown on the Plans. There will be a Q&A session at the end of the meeting The associated goals are 12% MBE and/or WBE, and 3% VBE. The MBE, WBE, and VBE utilization goals do not apply to the work assigned to the portions of the DCS work included as part of the Negotiated Price Item with the DCS manufacturer, Emerson and ABB. Should you have any questions, contact the Diversity Office at (312) 751-4035. The Project Manager for this contract is Jaroslaw Fink-Finowicki. This Project Manager will provide online responses to online inquiries.