Site work and paving for a road / highway in Henrieville, Utah. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Project consists of widening an existing roadway by building the shoulders out and applying a double chip seal. Also included is construction of a concrete low water crossing. Clearing and grubbing. Mobilization. Sawcutting. Remove asphalt. Excavation. Small ditch excavation. Untreated base course. Granular borrow. Double chip seal. Structural concrete. 12-inch csp. Sign, post, and base. Delineator. Traffic control. Nonresidential building construction services including commercial and office building new construction services and construction services and renovation and repair services. Construction services including sewer maintenance and repair, roads and highways and excavation and backfill services, levee and dam construction and digging, ditching, road grading, rock stabilization, equipment rental or lease, and energy conservation. Paving service including highway paving and road paving and infrastructure building services and parking lot and surfacing services. Construction Cost Estimate: $270,000.00 Question Deadline 01/26/2024 at 3:00 PM MT SCOPE This section of the specifications cover specific requirements, instructions, and conditions applicable to this project only, which are not covered by the General Conditions of the Construction Contract prepared by the Engineers Joint Contract Documents Committee. Should there be conflicting statements between this section and other sections of these specifications, this section shall govern. Should there be conflicting statements between the Standard General Conditions of the Construction Contract, these specifications or the Utah Division of Facilities Construction and Management (DFCM) Contracts Agreement. The order of precedence is as follows: 1. DFCM Contractors Agreement. 2. These Specifications 3. Standard General Conditions of the Construction Contract. The following documents are required before a certificate of occupancy and closeout of the project is issued: o A code inspection report recommending that a certificate of occupancy be issued. o Final report from the code/special inspection agency. o Certificate of fire clearance from the State Fire Marshall. o Final approval from the State Elevator inspector, if applicable. o Final approval from the State boiler inspector, if applicable. o Report of the disinfection of the potable water system. IPC 610 If Applicable o A Certificate of Compliance from the approved fabricator, if applicable. IBC 1074.2.2 N/A o A stamped and signed final report from the structural engineer when structural observation is required by IBC 1710. N/A o An NFRC Certificate for fenestration without the NFRC label, If Applicable o Final report from the special inspector and the mechanical engineer when smoke control is required. The reports must comply with IBC 909.18.8.3, If Applicable