Renovation of a municipal facility in Bergenfield, New Jersey. Completed plans call for the renovation of a municipal facility.

Reference Number 0000345155 Job Location Brookside Gardens, 293 Murray Hill Terrace, Bergenfield, NJ 07621 Buyer Preferences, Guidelines & Requirements General Requirements - Certification/Training - Certified Payroll - Contractors License Required - Installation Required - Insurance Required - License Required - Prevailing Wage Required Bonding Requirements - Bid Bond 10 % - Performance Bond 100 % - Maintenance Bond 100 % - Labor and Materials Bond 100 % Summary Of Scope Of Work: 1. This Project Includes Replacement Of The Existing Hot Water Boilers, Heating Pumps, And Associated Equipment, Piping, Valves, Etc. Refer To Dwgs. & Specs. For Add'l Info. 2. The Boiler Replacement Project Is A Single Prime Mech. Contractor Bid. This Contractor Is Responsible For All Work Associated W/ The Project Including Plumbing, Electrical, Etc. 3. The Following Sequence/approach Is To Be Followed, Unless The Contractor Comes Up With A Better Approach: A. Remove Exist. Boilers, & Burners, Control Panels, Piping, Breeching/flues, Electrical, Etc. B. Remove Exist. Heating Pumps & Related Piping, Valves, Etc. C. Sawcut Exist. Floor Slab To Remove Existing Floor Drains, Traps, Piping, Etc. Install New Floor Drains With Traps And Connect To Exist. Underground Waste Piping. Patch Floor Slab To Match Existing Floor. D. Pour New Concrete Pads For New Boilers, Pumps, & Other Boiler Room Equipment. E. Install New Boilers On New Concrete Pad, Complete W/ New Piping, Breeching/flues, Liner, Electrical, Etc. For A Complete & Operational System. F. Install New Heating Pumps On New Concrete Pad, Complete W/ New Piping, Valves, Electrical, Etc. G. Coordinate With Pse&g For The Gas Service Upgrades And Gas Tie-in. Pse&g Will Install New Gas Service To The Exist. Gas Service Location To Accommodate Gas Load Of New Boilers. Refer To Dwg. M2.01 For Add'l Pse&g Requirements. 4. Temporary Shutdown Of The Utility Service To The Building May Be Needed During Construction. Downtime Shall Be Kept To A Minimum And Work Shall Be Planned Accordingly. All Shutdown Shall Be Scheduled With Owner. 5. Perform All Associated Work As Indicated On Drawings And Specifications. 6. Provide Identification Labels, Tags & Flow Arrows For All New Equipment, Piping, Etc. 7. Provide New Boiler & Pump Controls W/ Tekmar Controller & All Control Devices To Start/stop, Lead/lag Boilers & Pumps For Max. Energy Efficiency. 8. Provide Startup Of New Boilers & Pumps, & Flue Gas Analysis Of New Boilers, & Tab. 9. Provide Two (2) Training Sessions, Spread Min. Four (4) Weeks Apart, On Proper Operation & Maintenance Of New Boiler System & Controls. 10. Provide Four (4) Copies Of One-time Chemical Treatment Report After The New Boiler System Is Installed & Tested. 11. Provide Two (2) Sets Of Hard Copies In Binders & Electronic Flash Drives Of All Closeout Documents, Including Question Deadline 03/22/2024 at 12:00 PM ET All questions must be submitted in writing via email to martinez@habcnj.org. Bonding Requirements - Bid Bond 10 % - Performance Bond 100 % - Maintenance Bond 100 % - Labor and Materials Bond 100 %