Renovation of a municipal facility in Edmond, Oklahoma. Completed plans call for the renovation of a municipal facility.

Cost Estimate: $138,000.00 Contact Person(s) for Questions: Doug Perkins - 405-715-9540 - Doug.Perkins@osbi.ok.gov Jerry Tate - 405-879-2633 - Jerry.Tate@osbi.ok.gov Leonardo Rodriguez - Leonardo.Rodriguez@omes.ok.gov If the bid exceeds $100,000, a cashier's check, a certified check or surety bid bond in the amount of five percent (5%) of the total bid is required. The certified or cashier's check must be delivered to the Owner's (Construction and Properties) Offices prior to the Bid Opening; other bid securities may be uploaded during the completion of online electronic bidding. Security checks will be returned to all but the three lowest bidders after the bid opening. The three lowest bid securities will be retained until the contract is awarded. 1.1 Contract resulting from this solicitation shall be for the purchase, removal, and installation of a laboratory grade open scroll air compressor system located on the 4th floor: 1.1.1 Properly disconnect and remove from site, the end-of-life triplex piston-driven oil-less air compressor system (including air receiver tank, air dryers, air purifiers, control panel, dew point monitor, carbon-monoxide detector, and skid package) on the fourth floor. This facility possesses a freight-sized elevator with a 5,000-pound capacity. 1.1.2 Replace the triplex piston-driven oil-less air compressor system with an open quadplex, highpressure, oil-less, 10HP, scroll-type air compressor system rated for a maximum of 145 PSIG. The delivered/installed scroll compressor system shall feature four (4) 10HP, oil-less scroll air compressors and all required associated equipment. Each compressor shall be belt-driven oil-less rotary scroll single stage of air-cooled construction. The rotary design shall not require any inlet or exhaust valves and shall be rated for 100% continuous duty. Tip seals shall be of a composite polytetrafluoroethylene (PTFE) material and be rated for 8,000 hours operation for 10HP pumps. Compressor bearings shall be external to the air compression chamber and shall all be serviceable for extended compressor life. Bearing maintenance shall not be required until 5,000 run hours. Compressors shall have an integral radial flow fan for cooling and shall not require any additional electric cooling fans. Each compressor shall have flexible connectors on intake and discharge, an electric drive motor, a discharge check valve, a fan-cooled aftercooler, a condensate separator, and a high discharge temperature shut down sensor/switch. Each compressor module shall have an isolation valve and a moisture separator with automatic drain plumbed to a local floor drain. The only field connections required shall be system air intake, air supply, and power connection (460VAC) at the control panel. All interconnecting piping, wiring, and vibration isolation pads shall be included with the system.