Site work and paving for a road / highway in Wascott, Wisconsin. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Estimated Completion Date shall be August 31, 2024. The undersigned bidder, if awarded the Contract, agrees to complete the work on or before the date stated in the specifications. The undersigned bidder, submitting this proposal, hereby declares and agrees to be bound, and to perform the work, in accordance with all terms, conditions and requirements of the within and foregoing proposal, the Contract, the applicable specifications, the special provisions, and the Advertisement for Bid, are made part, hereof, as fully and completely as if attached hereto. The bid must comply with all material requirements of the bid invitation and specifications. The Town reserves the right to reject any bid determined by the Town to be non-responsive. A bid can be determined as "non responsive" if the contractor added or deleted items from the bid, including, but not limited to, bids for a different type of paving than specified in the advertisement for bid. The Town may re-advertise for bids if the submitted bids are considered non responsive or if no bids are received. The Town reserves the right to reject any or all bids or portions of bids as determined to be in the best interest of the Town of Wascott. Bids will be awarded at the Regular Town Board Meeting on Tuesday, April 9 at 7:00 p.m. . Contract for Work - The work shall consist of furnishing all materials, equipment and labor for blacktop surfacing. . Surfacing - Blacktop construction shall conform to Sec. 450 of the WisDOT standard specifications. Mixture design shall conform to the applicable portions of Sec. 460 of the WisDOT standard specifications. The nominal compacted thickness of the blacktop pavement shall be 2 inches. . Surface preparation -Finish grading, watering and compacting of gravel surface shall be done by the paving contractor just ahead of paving. . Production - The contractor shall provide adequate trucks and paving equipment and compaction equipment to assure a continuous paving operation, achieve required in-place density and avoid frequent delays. After the asphalt paving has started, the contractor shall proceed to complete the project at the earliest possible date. . Warm Mix Asphalt Pavement Materials Shall be mix Type LT (No Air Void Regression) - The asphalt shall be performance graded PG58-28. The contractor shall provide a current mix design that will be used on the project. . Weather Conditions - Paving shall not be done when the temperature is below 40 degrees Fahrenheit or when rain is imminent. . A two foot minimum apron will be required at each driveway entrance.