Site work and paving for a road / highway in Greenville, North Carolina. Completed plans call for site work for a road / highway; and for paving for a road / highway.

The Engineering Department is accepting bids for the Thermoplastic Pavement Markings Project. Questions about this bid should be directed to Stacey Pigford, Civil Engineer II at 252.329.4678 or email at spigford@greenvillenc.gov. The City of Greenville, NC (City), is in need of a contractor to install thermoplastic pavement markings at selected locations in Greenville, NC. These markings will be installed over existing markings that are faded and in need of maintenance. All work and materials shall be in accordance with the provisions of the General Guidelines of this contract, the Project Special Provisions, the North Carolina Department of Transportation Standard Specifications for Roads and Structures, the North Carolina Department of Transportation Roadway Standards Drawings, the current edition of the Manual of Uniform Traffic Control Devices (MUTCD), and the Traffic Signal Specifications and all addenda. The Contractor shall keep himself fully informed of all Federal, State and local laws, ordinances, and regulations. SCOPE OF WORK The Contractor shall install HOT SPRAY and ALKYD-MALEIC thermoplastic markings in accordance with, and in conformance with the North Carolina Department of Transportation (NCDOT) Standard Specifications for Roads and Structures, and Amendments included elsewhere in this contract, NCDOT Roadway Standard Drawings, and the Federal Highway Administration (FHWA) Manual of Uniform Traffic Control Devices (MUTCD). The work covered by this special provision consists of marking the pavement surface with pavement markings to direct and control the movement of traffic and shall consist of remarking existing markings at locations specified herein. The Contractor shall furnish all services, labor, and equipment necessary for the required pavement preparation and pavement marking installation. Sufficient personnel experienced in the handling and application of the material shall be provided to assure work is done properly. The Contractor shall install the following markings with ALKYD-MALEIC thermoplastic. The items below will be measured in cost per each. 1. Left or Right Turn Arrows 2. Straight Arrow Symbols 3. Combination Straight Arrow and Left or Right Turn Arrow 4. Railroad Crossing Symbols, including Transverse bands 5. School Crossing Symbols, including traverse bands 6. "ONLY" Word Message The Contractor shall install the following markings with HOT SPRAY or ALKYDMALEIC thermoplastic. The items below will be measured in cost per linear foot. 7. 24" Stop Bar Lines 8. 12" Crosswalk Lines 9. 4" Yellow Center Lines 10. 4" White Skip Lines The quantities shown on the bid proposal form are a guide for bid prices, and it should be understood and agreed that the City is not obligated to install pavement markings in excess of its normal requirements. Questions must be asked in writing via email addressed to Stacey Pigford at spigford@greenvillenc.gov with the ITB #23-24-47 mentioned in the subject line of the email. All questions must be submitted by Wednesday, April 17, 2024 by 12:00 noon, and answers will be provided via an addendum posted on the City's website.