Site work and paving for a road / highway in Brentwood, Missouri. Completed plans call for site work for a road / highway; and for paving for a road / highway.

ASPHALT MILL & OVERLAY OF 1. S McKnight Rd (North bound lane from Litzsinger Rd to York Dr) 2. Litzsinger Rd (West bound lanes approaching McKnight Rd) 3. S McKnight Rd and Litzsinger Rd (Southeast corner) The date and time of receipt of a bid as noted by the City shall be final and conclusive for all purposes. All bids shall be made in duplicate on the printed forms found in the contract documents. Any contractor questions or concerns, or project site meetings, will be addressed by calling Eric Lake, Project Manager at 314-662-6035. Each bid must be accompanied by a certified check, cashier's check, or bid bond, payable to the City of Brentwood, MO, in the amount of (10%) of the total bid amount as a guarantee that the successful bidder or bidders will enter into contract and furnish performance and payment bonds in the full amount of the contract, at its own cost, from a bonding company with a Best's rating of at least B+/VII or greater within ten (10) days after the award is made. Accordingly, the cost of the performance and payment bonds should be included in the bid. The City of Brentwood hereby reserves the right to reject any and all bids, to waive any informalities in the bids received, and to accept the bid or bids that in its judgment will be in the best interest of the City of Brentwood. This work shall consist of labor, equipment, material, striping, and all other work service cost to provide the 2-inch mill and asphalt overlay of existing pavement as the base bid. The contractor is to provide all necessary traffic control measures and signage as necessary. Contractor is to provide all construction layout and staking. The work and materials to be furnished shall conform to the following specifications which are to be used in conjunction with the current editions of the St. Louis County Standard Specifications for Highway Construction and, as applicable, the Missouri Standard Specifications for Highway Construction. Any exceptions to these specifications must be noted in writing and included in the bid form. All bituminous asphalt pavement type C shall meet the requirements as specified in the St. Louis County Highway Department specifications for highway materials, sections 405 and 1015 or as currently revised. Asphalt pavement shall be 2 inches in depth of type C mix. All pavement marking methods, practices and materials shall meet Missouri Standard Specifications for Highway Constructions most recent version. All pavement markings shall be high acrylic waterborne equivalent to Hotline TM2152 with glass beads. All pavement markings shall be uniform in appearance with well-defined edges and shall be uniform in width and thickness. Deviation of pavement markings shall not exceed one (1) inch in one hundred (100) feet. The width of all four (4) inch pavement markings must be no less than four (4) inches and no greater than four and one quarter (4 1/4 ) inches. Paint shall be applied to a minimum wet thickness of 20 mils (0.508). Discoloration of pavement markings will be cause for rejection. The Contractor will take all precautions to prevent tracking. The surface on which paint markings are installed shall be clean and dry. Paint shall not be applied in damp conditions or if there is any evidence of surface moisture on the pavement. The pavement surface temperature and ambient air temperature shall be above 50oF and shall remain above 50oF for eight (8) hours immediately following the final application. o All pavement markings shall be installed in accordance with the manufacturer's specifications and recommendations.