Site work for a water / sewer project in Tuskegee Institute, Alabama. Completed plans call for site work for a water / sewer project.

PLEASE NOTE: The estimated value listed for this project is for searchability purposes only and does not reflect the actual construction budget as determined by the owner. It should not be used for estimation purposes at this time. Plans and specifications are for viewing purposes only and in order to be considered an official bidder contractors must obtain plans and specifications from Goodwyn Mills & Cawood Inc. The Project includes the following Work: Furnish and install approximately 700 radio read water meters, AMR meter reading system, valve replacement and all related appurtenances. Doc Notes: Prospective Bidders may examine the Bidding Documents at the Issuing Office Monday through Friday between the hours of 8:00 a.m. - 5:00 p.m., and may obtain copies of the Bidding Documents from the Issuing Office as described below .Partial sets of Bidding Documents will not be available from the Issuing Office. Neither Owner nor Engineer will be responsible for full or partial sets of Bidding Documents, including Addenda if any, obtained from sources other than the Issuing Office. This project is being funded by SRF Project No. FS010542-01 and will require DBE documentation from the low, responsive, responsible bidder no later than 10 days after the bid opening. This project is being supported, in whole or in part, by federal award number SLFRP2635 awarded to the State of Alabama by the U. S. Department of the Treasury. All participants must comply with all federal requirements applicable to the Loan (including those imposed by the 2014 Appropriations Act and related SRF Policy Guidelines) which the Participant understands includes, among other, requirements that all of the iron and steel products used in the Project are to be produced in the United States ("American Iron and Steel Requirement"). Owner Rights :The Owner reserves the right to waive any informalities, or to reject any or all bids, and to award the contract to the best and most responsible bidder. All bidders shall submit, upon request, a list of projects "successfully completed" in the last 2 years, having the same scope of work and approximate construction cost as specified in this project. All bidders must comply with requirements of the Contractor's Licensing Law of the State of Alabama and be certified for the type of work on which the proposal is submitted. Each bidder must deposit with his bid, security in the amount, form and subject to the conditions provided in the Instructions to Bidders. All Bidders bidding in amounts exceeding that established by the State Licensing Board for General Contractors must be licensed under the provisions of Title 34, Chapter 8, Code of Alabama, 1975, and must show evidence of license before bidding or bid will not be received or considered by the Engineer; the Bidder shall show such evidence by clearly displaying the license number on the outside of the envelope in which the Proposal is delivered. No bidder may withdraw his bid within 60 days after the opening thereof. Question Deadline 06/03/2024 at 12:00 PM CT Please be advised that all questions or comments for the above subject project will be accepted in writing from plan holders who have obtained bid documents from GMC. All questions or comments must be received in this office You can EMAIL your questions or comments to jeremy.lipscomb@gmcnetwork.com. Appropriate responses will be issued only to those items considered necessary by the Engineer via an addendum. The Project includes the following Work: Furnish and install approximately 700 radio read water meters, AMR meter reading system, valve replacement and all related appurtenances.