Remodeling and renovation of a military facility in Norco, California. Completed plans call for the remodel of a military facility.

This is a design build utility project. The scope of this project includes the replacement of electrical surface structures and dynamic protective devices at buildings 204, 506, 507, 514, and 544. The need for this replacement arises from the significant deterioration or defects that have been detected in at least some parts of these assets. It has become evident that these issues are affecting the functioning of the equipment, and therefore replacement is required. The electrical surface structures that require replacement may include wiring, conduits, switches, and other related components. All conductor and bus bars must be copper. The replacement may also involve upgrading the existing electrical system such as conduit, conductors and clearances to meet all current electrical and safety standards. Contractor is fully responsible to design and build fully operational systems that meet current UFC, SCE, NEC and all applicable standards, turning fully operational systems to the government. Contractor to submit all calculations for review. Provide an Electrical System complete in place, tested and approved, as specified throughout this RFP, as needed for a complete, usable and proper installation. Install all equipment in accordance with PTS Section G40 and the manufacturer's recommendations. Where the word "should" is used in the manufacturer's recommendations, substitute the word "must". ALL PRE-PROPOSAL INQUIRIES (PPI) SHALL BE SUBMITTED NO LATER THAN August 13, 2024, AT 11:00 AM PT. ALL PPI'S SHALL BE SUBMITTED BY THE PRIME CONTRACTORS AND EMAILED TO ME AT santiago.d.rodrigues.civ@us.navy.mil. If you have any questions, please contact me at santiago.d.rodrigues.civ@us.navy.mil or (562) 626-6110. The Range of Magnitude of the Construction Project is between $1,000,000 and $5,000,000.