Renovation of a detention facility in Bath, Ontario. Completed plans call for the renovation of a detention facility.

This bid solicitation cancels and supersedes previous bid solicitation numbers: 21423-23-4357694 dated 2023/04/21 that closed on 2023/05/25 at 10:00EST and 21421-25-4883316 dated 2024-10-29 that closed on 2024-12-03 at 10:00EST. CSC will provide a debriefing or feedback session upon request to bidders who bid on the previous solicitations. The Correctional Service of Canada requires the services of a qualified contractor to supply and install two (2) new radiators for a CUMMINS QSK60-G6 generator. Objectives: To replace two (2) leaking radiators with two (2) new compatible Cummins radiators. The Contractor must: - Drain the engine coolant from the current radiator assemblies and dispose of it as per all Federal and Provincial environmental safety codes and regulations. - Remove front end enclosure housing panels to permit radiator removal. - Remove the two leaking radiators, disposing of them offsite as per all Federal and Provincial environmental safety codes and regulations. - Supply and install two (2) new Cummins radiators, with full length header plates. - Replace all gaskets (fibre) and sealant. - Replace all thermostats. - Replace all radiator hoses. - Supply and fill radiators with new engine coolant as per all Federal and Provincial environmental safety codes and regulations. - Install two (2) radiator heaters with integral pumps (to reduce thermal expansion shock). - Re-assemble entire enclosure housing. - Supply, connect and fuel a temporary, two-point-two (2.2) gigawatt generator for the entire period that the Bath generator will be offline. - Ensure the temporary generator automatically starts and provides power to both Bath and Millhaven Institutions within ten (10) seconds in the event of power loss from the distribution grid. - Disconnect and remove the temporary generator from the site once replacement of the new radiators is complete. - Ensure the CUMMINS QSK60-G6 generator is reconnected and functioning as required. Construction time: The Contractor must perform and complete the Work on or before March 31st, 2025. Documents can be obtained at: https://canadabuys.canada.ca/en/tender-opportunities enquiries should be received no later than five (5) business days prior to the date set for solicitation closing to allow sufficient time to provide a response.