Renovation of a playground / park / athletic field in Apple Valley, Minnesota. Completed plans call for the renovation of a playground / park / athletic field.

SCOPE OF WORK The following outlines the scope of work for this project. Materials to Purchase The following is a list of material the contractor will need to provide for this work. It is not a complete list of materials but covers most of the larger items needed: o 1 Trove 2 Enclosure o Conduit (amount to be determined by contractor) o Category 6 ethernet cable (amount to be determined by contractor) o Electrical wire (amount and size to be determined by contractor) o 1 LNL-X2220 access panel o 1 LNL-X1320 reader board o 2 HID Signo 20 card readers (standard profile) o 1 HID Signo 40 card reader (standard profile) o 1 Altronix power supply o 2 GRI surface mounted double pole/double throw door contacts o 2 Bosch DS160 request to exit o 2 Von Duprin 6210 Electric Strike o 1 Alarm Control DPDT Monitor and Control Station o 4 Axis P3267-LVE o 4 Avigilon 7.0 Enterprise camera licenses Contractor Responsibilities The following is a list of tasks the contractor is responsible to complete. o Install the Axis P3267-LVE cameras on the building as indicated. o Run CAT6 cable between the county switches and the installed Axis cameras. o Install the purchased Trove 2 enclosure in the site's office room. o Install the purchased LNL-X2220 and Altronix power supply in the mounted Trove 2 enclosure. o Install the purchased LNL-X1320 in the mounted Trove 2 enclosure. o Install the purchased HID Signo 20 card reader on the laundry room door frame. o Install the purchased HID Signo 20 card reader on the main entrance. o Install the purchased HID Signo 40 card reader above the intrusion keypad. o Install the purchased Alarm Control monitor and control station near the intrusion panel. o Install the GRI door contacts on the main entry door and the laundry room door. o Install the Bosch DS160 REXs on the interior above the main entry door and the laundry room door. o Install the Von Duprin 6210 electric strikes on the main entry and mechanical room door frames. o Wire the Altronix power supply to power the LNL-X2220 reader board. o Install any surface mounted conduit to conceal wires in the building. Conduit is needed only where wires would otherwise be visible in normal building use (i.e. conduit is not needed if wire is being run through the ceiling) o Wire the installed door contacts, electric strikes, REXs, control station, and card readers to the Lenel access and reader boards. o The door contacts will be wired to the intrusion panel and the card access system. o Program the Signo 40 card reader to arm the existing Bosch intrusion panel. o Program the 3 installed card readers into the County's OnGuard 8.2 card access software. o Program the Alarm Control DPDT control station to change the reader mode of the main entry reader and laundry room reader in OnGuard 8.2. Dakota County Staff Responsibilities The following is a list of tasks the county is responsible to complete for the contractor. o Provide the contractor with the network switch information. o Provide the contractor with access to the site. o Ensure there is switch port availability for the network devices.