Renovation of an educational facility in Rio Linda, California. Completed plans call for the renovation of a educational facility.

Bid results will be posted on SecureBids once bids have been reviewed. For a copy of the solicitation and full bid details, please visit website, Provide temporary fencing to store materials onsite and at staging areas. 2. New roof system will have crickets to direct water around all curb mounted roof penetrations. 3. Install walkway roll under downspouts that drain onto the roof. 4. All wood blocks will be replaced with new rubber blocks. Install DBR series Durablok or similar with adjustable all-thread. Wide pipe runs with multiple conduit lines will require two blocks with Unistrut in between to support the pipes. 5. Typical edge metal will be 4" with a continuous cleat unless specified differently in the scopes below. 6. Install 24-gauge galvanized skirt metal at HVAC units per typical curb detail. 7. Install new 24-gauge galvanized counterflashing at roof to wall terminations. 8. Clean and paint clamping rings and dome strainers with blue paint before reinstalling. Replace any broken drain bolts or dome strainers. 9. Do not install walkway roll over seams in single ply roof. 10. Water-test all drains and plumbing assemblies prior to starting the project. Report any leaks to the District immediately. Contractor will be responsible for any drain or plumbing connection leak repairs after the new roof is installed. 11. Snake drains to nearest cleanout before starting installation of new roof system. Contact District immediately if drain cannot be cleared. 12. Use drain plugs when roof is being removed. Rags are not acceptable for preventing debris from entering the plumbing