Renovation of an educational facility in Cambridge, Ohio. Completed plans call for the renovation of a educational facility.

Cambridge Window Replacement The EDGE Participation Goal for the Project is <<5.0>> percent. Bid tabulations will be posted no later than 5:00 p.m. on the day Bids are opened. Question Deadline 03/31/2025 at 10:00 AM ET Any questions regarding project scope of work or bid process prior to submitting a bid please contact: Lisa A. Lawrence Planner 2 Ohio Department of Public Safety 1970 W. Broad Street, Columbus, OH 43223 614-752-7861 | LLawrence@dps.ohio.gov Bidders may submit requests for consideration of a proposed Substitution for a specified product, equipment, or service to the Architect/Engineer ("A/E") no later than 10 days prior to the bid opening. Additional products, equipment, and services may be accepted as approved Substitutions only by written Addendum. The time for Substantial Completion of all Work is 180 consecutive days from the Commencement Date in the Notice to Proceed. Prevailing Wage rates and Equal Employment Opportunity requirements are applicable to this Project. 1.Please review project manual and drawings for complete scope of work 1.Do not scale drawings. 2. All dimensions must be field verified and the owner / architect must be Notified of any discrepancies before proceeding with the work. 3. All interior dimensions are to face of gypsum board unless noted Otherwise. 4. Coordinate locations and/or elevations of floor drains, registers, Grilles, louvers, convectors, cabinet unit heaters, panels, etc. With Adjacent work and trades. 5. All dimensions and tie-ins governed by existing conditions are Approximate. All such dimensions and conditions shall be field verified by the contractor, prior to the preparation of shop drawings and before Proceeding with any work. The first submittal of shop drawings must Contain correct conditions and dimensions obtained from the field. If Conditions and dimensions vary greatly from those shown, the contractor Shall notify the owner / architect before preparation of shop drawings, and before proceeding with work. 6. Demolition work shown should be coordinated with all construction Documents for final dimensions and details necessary to define exact limits and/or of demolition. 7. Contractor shall coordinate the necessary permits, approvals and Guidelines from governing regulatory agencies. Construction work will Not proceed until all required regulatory approvals have been issued. (Owner shall obtain state plan approval through industrial compliance. Full plan approval will be completed in conjunction with contractor shop Drawings reviewed / approval with owner / architect.) 8. Ceiling height(s) noted on drawings for rooms or areas is the height from finished floor surface to finished ceiling or where no finished ceiling Is called for, the ceiling height(s) noted is the minimum required headroom Clearance from finished floor to underside (low point) of pipes, ducts, Conduits, light fixtures, and similar exposed or suspended items or Equipment.