Site work for an educational facility in Oceanside, California. Completed plans call for site work for a educational facility.

Remove and replace perimeter fencing and gates SCOPE OF WORK: Remove and replace roughly 2,200 linear feet of chain link fencing with 5 man gates (contractor will verify linear footage). Remove and dispose of all existing fencing fabric, screen, posts, rails, gates, wire, footings, and hardware. Question Deadline 04/14/2025 at 2:00 PM PT Online Q&A Yes License Requirements C-13 - Fencing Contractors or A General Engineering Contractor Bid Bond 10.00% Payment Bond 100.00% Performance Bond 100.00% DVBE (3%) FENCE POSTS: All line posts will be 2 3/8 " diameter schedule 40 galvanized steel pipe, vinyl coated black, and spaced at a maximum of 10' feet. All 6' foot high fencing will have top and bottom rails made of 1 5/8 " diameter schedule 40 galvanized steel pipe vinyl coated black. All corner, end, and pull posts shall be minimum 2 7/8 " inch diameter galvanized steel pipe vinyl coated black. Pull posts will be used at all abrupt changes and at intervals no greater than 500' feet. FABRIC: Fabric will be 2" inch chain link mesh, (9 gauge) galvanized steel with black vinyl coating. Fabric will be stretched taut 2" inches above ground level and securely fastened to fence line and terminal posts. Fastening to terminal posts will be with tension bars and tension bands at 12" inch intervals. Fastening at line posts shall be with post ties spaced at 12" inch intervals. Fastening to top rail will be with rail ties at 18" inch intervals. Fabric will be knuckled selvage at top and bottom. GATES: Gate posts will be 3" inch diameter schedule 40 galvanized steel pipe vinyl coated black for all gates less than 5' wide. Gate posts will be 4" inch diameter schedule 40 galvanized steel pipe vinyl coated black for all gates greater than 5' feet wide and less than or equal to 10' feet wide. All gates will be constructed of 1 7/8 " inch diameter schedule 40 galvanized steel pipe vinyl coated black. Corners and end posts to be box braced. HARDWARE: All hardware will be of school grade including: post caps, gate hinges, tension bars, tension bands, rail ends, eye tops, hog rings, ties, etc. All black vinyl coated. All nuts, bolts, washers, etc. to be of galvanized steel, primered, and painted black after installation. FOOTINGS: All line posts 2 3/8 " diameter and 8' feet to be set in 12" x 24" inch post holes with 3,000psi concrete and dome finished. All corner and end line posts to be set in 12" x 36" inch post holes with 3,000psi concrete and dome finish.