Site work and paving for a road / highway in Magnetawan, Ontario. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Slurry Seal Surface Treatment The Municipality requires an estimated 46,600m2 of Slurry Seal Surface Treatment at two (2) locations in the Municipality of Magnetawan. See below under Services Required. The Contractor must verify the work envelope dimensions. The slurry seal shall be applied in accordance with all appropriate industry standards and Ontario Provincial Standards Specification (OPSS), with quality workmanship and materials. It is essential that the slurry applications do not form a seam at the centerline, but in fact overlap same in order to seal the crown. It is essential that precautions be taken to prevent oil-based products and by-products from entering any neighbouring waterbody. The slurry seal shall continue into the aprons of intersecting streets to the lesser of five (5) metres, or the termination of the asphalt. The asphalt emulsion shall be rapid setting type designed for Slurry Seal work. The aggregate will consist of clean, sound, durable limestone screenings which shall be free of clay, loam, and other deleterious materials. Portland cement mineral filler shall be considered part of the blended aggregate. The final aggregate gradation including mineral fillers, if required, shall fall within Type ll Gradation for Slurry Seal from OPSS 337. All water used with the Slurry Seal mixture shall be potable and free from harmful soluble salt. Application rate testing will be carried out by the Contractor if requested by the Owner at no additional cost. The Contractor is to supply all equipment required for application rate testing. Sweeping and/or vacuum type sweeping of existing surface as required prior to placement of Slurry Seal to be done by the Contractor and be included in the price. Stockpiling of refuse sand in working areas for pick up later can be negotiated with the Roads Staff and be reflected in the price. Book 7 Temporary Conditions traffic controls are to be implemented by contractor. It is essential that controlled traffic flow be permitted. However, this must be done in a way that does not compromise the quality of the finished work, especially with regards to curing time. Damage to Highways If, in the opinion of the Director of Public Works, or his agent, damage is being done, or is likely to be done, to any highway, or any improvement thereon, other than such as in part of the work, by the Contractor's vehicles or other equipment, whether licensed or unlicensed, the Contractor shall, at the direction of the Director of Public Works, or his/her agent, at the Contractor's own expense, make changes in, or substitutions for such vehicles and, or, equipment or, shall alter loadings or shall in some other manner remove the cause of such damage to the satisfaction of the Director of Public Works or his/her agent. Vehicle Loading Weighing shall be carried out in accordance with OPSS 102, or the latest revision thereof. Where a vehicle is hauling material for use on the work under this contract, in whole or in part on a public highway, and where motor vehicle registration is required, the Contractor shall not permit any vehicle in his/her employ to be loaded beyond said legal limit. Spills Reporting Spills or discharges of pollutants or contaminates under the control of the Contractor, and spills or discharges of pollutants or contaminants that are the result of the Contractor's operations that cause or are likely to cause adverse effects shall forthwith be reported to the Contract Administrator. Such spills or discharges and their adverse effects shall be as defined in the Environmental Protection Act R.S.O. 1980. This reporting shall not relieve the Contractor of his/her legislated responsibilities regarding such spills or discharges. Any foreseen problems with these conditions should be addressed to the Superintendent of Public Works. There shall be no sub-contracting of the work by the contractor without the written approval of the Scott Edwards, Superintendent of Public Works. The contractor is to provide all required equipment and materials required for the re-surfacing work (there are several quarries in the area). The services to be provided by the successful Bidder will include but not be limited to those areas as set out below. Generally, services provided by the successful Bidder in each area shall include but not be limited to: A penalty of $500.00/day, at the Municipality's discretion may be applied if agreed to quantities are not supplied on schedule. meet the specification within this Proposal, then the Municipality has the right to refuse material, be reimbursed for the inferior material and award the remainder of the contract to another Bidder. West Poverty Bay from Magnet Rd to Old Highway Rd Estimated 18,600 square metre A certified cheque made payable to the Municipality of Magnetawan in the amount of ten per cent (10%) of the total estimated Proposal Proof of payment by e-transfer in the amount of ten percent (10%) of the total estimated Proposal. A completed Performance Bond be signed and sealed by a recognized Bonding Company, in the amount of ten percent (10%) of the total estimated Proposal All questions or inquiries must be made in writing or email to the Lead Contact named below by the specified date and time: Scott Edwards Public Works Superintendent PO Box 70, 4304 Hwy 520 Magnetawan, ON P0A 1P0 publicworks@magnetawan.com Docs can be obtained from https://www.biddingo.com/dashboard/bid/1/41043140/40394728/verification