Renovation of a military facility in Gillett, Arkansas. Completed plans call for the renovation of a military facility.

The National Park Service, Contracting Operations Central, intends to issue a Request for Quote (RFQ) for the Replace DP-2 Panel and Restore Power project for Arkansas Post National Monument in Gillette, AR. Work consists of: The disconnection and removal of existing distribution panel DP-2 which is fed direct from the main distribution panel (MDP) and located within the mechanical room of the visitor center (VC). The contractor shall provide and install a new NEMA 3R rated enclosure to house a new single phase, 800amp, 240v panel. Existing electrical service from panel DP-2 which is routed by conduit up through the floor of the mechanical room shall be extended through the wall and re-connected to the new panel DP-2 as indicated in the ion drawings. NUMBER: 140P6025Q0040 PROJECT MAGNITUDE: Between 100,000 and 250,000 TYPE OF CONTRACT: This will be a firm-fixed price contract expected to be awarded to a prime contractor by Summer 2025 with to begin in Summer 2025. ion Wage Rate Requirements for Arkansas County, AR will apply. EVALUATION FACTORS: Technical, Past , and Price North American Industry Classification System (NAICS) CODE CLASSIFICATION and SET ASIDE: The NAICS Code is 238210, and the size standard is 19 million. This project is set aside 100 for Total Small Businesses. : A date, time, and meeting will be announced in the . Offerors are highly encouraged to attend the scheduled to inspect the site and to ensure they fully understand the requirement and conditions that may affect the cost of the project, specifications, and . PUBLICIZING: The official and its attachments will be issued and available June 2025 and will be posted to the Contract Opportunities/SAM.gov website at https://sam.gov/content/opportunities . The contracting office will not provide hardcopies or copies of the . REGISTRATIONS: In order to be awarded a contract, an offeror must have an UEI number. Also, the offeror must be registered and active in the System for Award Management (SAM), website at http://www.sam.gov, and have completed their Online Representations and Certifications at the time of the close date once the is posted. POINT OF CONTACT: Bridget Parizek, Contracting Officer, bridget_parizeknps.gov, 402-800-7927. : All shall be submitted in writing to bridget_parizeknps.gov. All must be submitted in writing no later than June 17, 2025. *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. Project work consists of: The disconnection and removal of existing distribution panel DP-2 which is fed direct from the main distribution panel (MDP) and located within the mechanical room of the visitor center (VC). The contractor shall provide and install a new NEMA 3R rated enclosure to house a new single phase, 800amp, 240v panel. Existing electrical service from panel DP-2 which is routed by conduit up through the floor of the mechanical room shall be extended through the wall and re-connected to the new panel DP-2 as indicated in the ion drawings. The Contractor shall additionally identify the point of connection of electrical service from the VC fire alarm system located within the same mechanical room as panel DP-2 (approximately 8 feet away horizontally) and establish a direct wire route within conduit to new panel DP-2 and terminate at new dedicated circuits. As bid additive, should NPS elect to award, the Contractor shall restore electrical connection which serves a series of duplex receptacles which were severed within a single 1" galvanized conduit encapsulated within a CMU and Grout filled cavity of the exterior wall. The severed connection is due to installation of a new thru-wall mechanical louver under a separate contract. Work is to include core drill below the existing louver to intercept the conduit, install new wall mounted junction box(es), and route wiring in CO approved manner to establish restored connection to subpanel L-1 in adjacent room. See ion drawings for representative photos and further information. Additional requirements information is provided in the , specifications, supporting documents and other pertinent attachments.