Site work and paving for a road / highway in Deforest, Wisconsin. Completed plans call for site work for a road / highway; and for paving for a road / highway.

As of July 15, 2025. Project was awarded to Fahrner Asphalt but awarded amount is not available. This Year Includes a Total of Approximately 4.89 Miles of Chip Sealing on Various Roads. Bids Should Be Based on 4.02 Miles of Roads With 3/8-inch Quartz Rock Chip Material With a Minimum of Three Compacting Rollers Used in the Application Process and a Single Seal. In Addition, Included in the Bid Will Be .87 Miles of Chip Sealing On Various Roads With 1/4-inch Quartz Rock Chip Material With a Minimum of Three Compacting Rollers Used in the Application Process and a Single Seal. The .87 Miles of Road Would Also Include Sweeping Excess Material. Immediately before applying the asphaltic material, the existing surface shall be cleaned with a power broom or other suitable equipment to remove dirt, clay, or other objectionable matter. Apply asphaltic material only when the air temperature is 60 degrees Fahrenheit or more and the surface is dry and reasonably free ofloose dirt, dust, or other foreign matter. Do not apply if weather or surface conditions are unfavorable or before impending rains. An asphaltic material shall be applied at a rate sufficient to provide 70% embedment ofthe aggregate chip into the asphalt after the asphalt has cured and the road is open to traffic. Cover previously applied material as required to create transverse joints without overlapping. 6. Treated areas shall be closed to traffic until after the initial rolling of the cover aggregate has been completed Any Questions, Please Call (608) 846-3800. The Town of Vienna Reserves The Right to Reject Any and All Bids, to Waive Any Technicality And to Accept Any Bid That It Deems Advantageous. The Contract Award Shall Be Made Based on the Lowest Responsive And Responsible Bidder After the asphaltic material develops sufficient tackiness, aggregate shall be uniformly spread over the treated surface. The aggregate shall be damp to surface dry when applied. Aggregate shah be applied at a rate to completely cover the treated surface but limited to an amount easily embedded in and bonded by the asphaltic material. The surface shall be rolled immediately after spreading the aggregate, beginning at the edges, and continuing to the center, lapping 1/2 the roller width on each successive pass. After the initial rolling, perform subsequent rolling until the aggregate is thoroughly embedded and the surface is smooth and uniform in texture. Roller speed shall not exceed 5 mph and care should be taken when reversing roller direction to avoid displacing or loosening the covered aggregate or damaging the asphaltic material. All rolling shall be completed with pneumatic rollers of good operating condition. Bld for 4.02 mhes of 3/8-inch quartz rock: -Schumacher Road - Approximately 3.03 miles of road (Map 1) County Hwy V to Easy Street -Daley Road = Approximately .99 miles of road (Map 2) -County Hwy I to Hickory Lane Bid for .87 mifos of 1/4-inch quartz rock with sweeping: Vienna Drive and outlets; -Locust Lane (.10 Mile) (Map 3) -Aspen Court (.07 Mile) (Map 4) Beech Court (.10 mile) (Map 5) -Vienna Drive (.60 mile) (Map 6) NOTE: The above milage was compiled using GIS-, Contractor is responsible for verifying distances and quantities for an ad-enoempassirsg lump sum bid.