Site work for a water / sewer project in Red Wing, Minnesota. Completed plans call for site work for a water / sewer project.

The project includes the following work on the 1,200,000-gallon, partially buried, concrete ground storage reservoir that is estimated to have been constructed in the 1940's. Repairs have been made to the reservoir over the years, with the most notable being a new shotcrete style cap over the entire roof. 1. Cleaning and repairing the interior and exterior concrete roof, walls, and floor. 2. Structure modifications and surface repairs. Reservoir out-of-service schedule to start on September 3, 2025 and end by October 31, 2025. SCOPE Regulatory Requirements This specification covers the requirements for worker protection, environmental protection, and the handling of debris generated from industrial paint removal. It is consistent with the intent of these contract documents to describe those performance standards, often broad and general in nature, required to provide a complete and operating system. It shall be the responsibility of the Contractor to familiarize themselves fully regarding the detailed needs and requirements of any and all regulatory agencies having jurisdiction over this work. These detailed needs and requirements shall be accommodated, as part of the Work, in every manner just as if they were prescribed in these Contract Documents. The Contractor shall comply with and have documented Confined Entry Space Procedures available at the reservoir site at all times, as required by OSHA 29 CFR 1910.146. The Contractor shall also comply with any state and/or local requirements which are more restrictive than the federal requirements. The Contractor shall comply with safe working practices for cleaning, burning, welding, and handling non-lead-based coated steel, and all health and safety regulations and requirements of federal, state, and local health regulatory agencies, and any Safety Data Sheets (SDS). This compliance shall be accomplished without supervision from the Engineer, or other direct or indirect agents of the Engineer. All rigging attachments present on the reservoir shall be carefully inspected by the Contractor immediately prior to use. The Contractor assumes all responsibility for use of any existing or added attachments. Question Deadline 06/24/2025 questions shall be addressed to KLM Engineering, Inc., 1976 Wooddale Drive, Suite 4, Woodbury, MN 55125, attention Benjamin Feldman, Project Engineer or by email to bfeldman@klmengineering.com.