Site work for a mixed-use development in Bradenton, Florida. Completed plans call for site work for a road / highway; and sidewalk / parking lot.

The City of Bradenton is seeking bids from Contractors to provide all materials, labor, and equipment for placement and/or replacement of roadway pavement striping and markings for pavement striping services. This work includes, but is not limited to, pavement edge lines, stop bars, crosswalks, skip traffic stripes, solid traffic stripes, directional arrows, pavement messages, island nose reflective paint, reflective pavement markers and flexible breakaway delineator posts in various areas within the City of Bradenton. Question Submission Deadline:June 23, 2025, 5:00pm. A. The Contractor shall provide maintenance of traffic in accordance with the latest Florida Department of Transportation (FDOT) Standard Plans FY 25-26 as amended for the project. Failure to comply with this requirement will result in complete shutdown by the City with no additional compensation to the Contractor. Driveway access shall be always maintained. Procurement Contact Nicholas Toth Purchasing Analyst nicholas.toth@bradentonfl.gov (941) 714-7504 B. All work must be performed following the 11th edition Manual on Uniform Traffic Control Devices (MUTCD) as amended and the latest Florida Department of Transportation (FDOT) specifications for road and bridge construction. C. The Contractor shall provide sufficient signage, proper flagging operations and barricade placement to ensure the safety of Vehicular and Pedestrian traffic at all locations where work is being done for this project. D. The Contractor shall always maintain a good and sufficient fence, railing or barrier around all exposed portions of said work in such a manner as to warn vehicular and pedestrian traffic of hazardous conditions. Should the Contractor fail to properly barricade his work or stored material sites in the manner outlined above, the City may have the necessary barricading done, and all cost incurred for said barricading shall be charged to the Contractor. E. The Contractor will refurbish existing striping and pavement markings utilizing water-based traffic paint or thermoplastic, depending on the existing conditions and project specifications. F. New pavement striping and markings shall be applied using water-based traffic paint or thermoplastic, ensuring compliance with local and national standards G. The Contractor will remove existing striping and pavement markings as required, ensuring that the surface is prepared for new application. H. Removal of existing reflective pavement markers (RPMs) shall be completed as necessary, with the installation of new or replacement RPMs where specified. I. The Contractor shall follow industry-standard traffic control and safety procedures during the installation of striping and pavement markers.