Site work and outdoor lighting for a playground / park / athletic field in Morgan, Utah. Completed plans call for site work for a playground / park / athletic field; and for outdoor lighting for a playground / park / athletic field.

The fairgrounds is in need of more power to support food trucks, vendors, and future buildings. o Set a 1200amp 3phase switch gear centrally located by the flagpole. Which will support 2-400amp 3phase outdoor panels and 1-200amp 3phase outdoor panel. The switch gear will have spare breakers and spaces for a future exhibit building, bathrooms and much more. o Panel-A will be located about center of the arena behind the bleachers on the concessions side. o Panel-B will be located behind the practice arena bleachers. o Panel-C which is the 200amp 3phase panel will be located by the bounce house and poultry area. Panels should support 24 total pedestals with 1-50amp 220volt outlet and 1- 20amp 120volt GFCI outlet. These panels should have room for future growth. Remove all 7-lighting poles from existing cement foundations, (metal poles and fixtures area to be turned over to the county to demo as needed) Two light poles on the North side are to be cut down at least 6"below exiting grade (Cement poles to be hauled off by Contractor) Four new precast light pole foundations are to be augured in new locations, set and cemented in place as per plan. (Spoils are to be hauled off by Contractor) New wire is to be pulled into all lights using existing conduit (Assuming all existing conduit is in good enough shape to re-pull in new wire) Install new control box near existing panel for simple on/off controls for the four new precast light poles.