Site work, paving and outdoor lighting for a mixed-use development in Lexington, Kentucky. Completed plans call for site work for a bridge / tunnel; for paving for a bridge / tunnel; sidewalk / parking lot; sidewalk / parking lot; and for outdoor lighting for a sidewalk / parking lot.

Lighting for Brighton Trail Question Deadline 09/01/2025 at 12:00 PM ET If you have questions concerning quotes specifications or the quote process, please submit questions online, Questions by phone or email are not accepted and are directed to the aforementioned website. The electrical contractor will furnish all materials, labor and obtain the required permits and inspections to complete the following scope of work. All work to be installed in compliance with NEC and LGEKU regulations. . Bore from underground LGEKU electrical service box to Star Shoot Parkway bridge + - 385'. . Install conduit 24" deep turned up into LGEKU box and at meter pedestal location. . Install one meter base pedestal, panel and service disconnect to support 100 AMP service. Panel to be Square D. . Install two vandal proof exterior ceiling flush mount 40-watt light packs under bridge to provide adequate illumination under bridge. . Lights to be controlled by photocells mounted on the exterior face of the bridge. . All electrical service wires on and under bridge are to be installed in flexible conduit, conduit must be secured to the bridge to prevent sagging. . Cap existing exposed electrical wires under bridge and install cover plates over the light junction box. . The contractor shall complete the scope of work within 21 days from notice to proceed. . All open excavations should be covered and blocked by a physical barrier when work is not being performed. . The contractor is responsible for obtaining all required permits. . The contractor is to coordinate with LGEKU to have the underground electrical box accessed. . The contractor will submit all material specifications to LFUCG Project Manager prior to installation. . The contractor will complete an LGEKU load sheet and submit it to LFUCG Project Manager prior to beginning installation.