Site work for an educational facility in Danville, Illinois. Working plans call for site work for a educational facility.

As of 10/29/2025, These bids came in higher than expected. DACC is not planning to accept these bids and will not be awarding a contract at this time. For Technology Center Dust Collector Mechanical Email questions to GHR Engineers and Associates, Inc. Telephone (voice) queries are discouraged. 1. Email: shicks@ghrinc.com 2. Use the following subject line: "Danville Area Community College - Technology Center - Dust Collector". B. Bidder's questions will not be taken after 2:00 pm on Thursday, October 9, 2025 unless the bid opening date is changed by addendum. WORK INCLUDES A. Work covered by contract documents: 1. Bid Package 1: Installation of Owner-provided dust collector on grade, associated ductwork, spark detection and abort gate damper. See Sheet M1.SUMMARY A. Project identification: Danville Area Community College - Technology Center - Dust Collector B. Bid Package 1: Installation of Owner-provided dust collector on grade, associated ductwork, spark detection and abort gate damper. See Sheet M1. C. Particular project requirements: 1. 2. Existing site conditions and restrictions: The building will be occupied at the time of construction and care must be taken not to disturb normal operations of the occupants. D. Permits: Apply for, obtain, and pay for permits required to perform the work. Submit copies to Architect and Owner. E. Codes: Comply with applicable codes and regulations of authorities having jurisdiction. Submit copies of inspection reports, notices and similar communications to Architect. F. Dimensions: Verify dimensions indicated on drawings with field dimensions before fabrication or ordering of materials. Do not scale drawings. G. Existing Conditions: Notify Architect and Owner of existing conditions differing from those indicated on the drawings. Do not remove or alter structural components without prior written approval. H. Definition for terms used in the Specifications: 1. 2. Provide: Furnish and install, complete with all necessary accessories, ready for intended use. Pay for all related costs. 3. Approved: Acceptance of item submitted for approval. Not a limitation or release for compliance with the Contract Documents or regulatory requirements. Refer to limitations of "Approved" in General and Supplementary Conditions. 4. Match Existing: Match existing as acceptable to the Architect and Owner. 5. Intent: Drawings and Specifications are intended to provide the basis for proper completion of the work suitable for the intended use of the Architect and Owner. Anything not expressly set forth but which is reasonable implied or necessary for proper performance of the project shall be included.