Renovation of a residential development in Baltimore, Maryland. Completed plans call for the renovation of a residential development.

The Contractor shall supply all labor, material, supervision, equipment, insurance, permits including U&O (Unit of Occupancy Permit) and all other incidentals required to complete the work items listed below as requested by HABC, in accordance with all applicable federal, state and local regulations. Completion: 30 days from Notice to Proceed. 1667 Bakbury Ct General: 1. Remove and properly dispose of all Trash, Furniture and Miscellaneous Items in the Unit. 2. Replace closet shelving/closet rod as necessary 3. Final Cleaning of Entire Unit to Make Ready for Occupancy. Bathrooms: 1. Remove existing sink, supply and install new Vanity Cabinet w/ Vanity Bowl, faucet and stainless steel 1-1/4" drain line. 2. Clean existing toilet and replace toilet seat 3. Remove existing, supply and install New Medicine Cabinet with Mirror 4. Remove existing, supply and install all new bathroom Accessories, Non-UFAS 5. Clean existing tub, shower wall, tub faucet, tub spout and showerhead. 6. Remove existing shower rod, supply and install new shower rod 2 nd floor Hallway 1. Replace pantry door in hallway Kitchen: 1. Remove existing rangehood, supply and install Broan #4100 range hood (Black) 2. Clean existing kitchen cabinets Repair any loose hinges on cabinet doors. 3. Clean existing countertop. 4. Remove existing kitchen faucet, supply and install new Delta faucet 5. Remove existing kitchen sink drain line, supply and install new stainless steel 1-1/2" (inch) drain line. 6. Check existing washer box , supply and install laundry hookup box and hot /cold water valves if needed. Bedroom # 1: 1. Remove existing vertical window blinds, supply and install new vertical window blinds (2) 2. Clean exterior and interior of heating convector of any debris. 3. Clean window frame including sills and wells (Lead Testing) and window glass. 4. Paint existing Closet shelf and pole. Bedroom # 2: 1. Remove existing window blinds, supply and install new window blinds (2) 2. Remove existing receptacle covers, supply and install new receptacle covers 3. Clean exterior and interior of heating convector of any debris. 4. Clean window frame including sills and wells (Lead Testing) and window glass 5. Paint existing closet shelf and pole. Livingroom: 1. Remove existing window blinds, supply and install new window blinds (2) 2. Clean window frame including sills and wells (Lead Testing) and window glass 3. Remove existing receptacle covers, supply and install new receptacle covers 4. Clean exterior and interior of heating convector of any debris. 5. Clean window frame including sills and wells (Lead Testing) and window glass 6. Paint existing closet shelf and pole. Mechanical / Plumbing: 1. Check and Inspect Gas Distribution (Stove) for service and repair any leaks. 2. Water Distribution (Bathroom & Kitchen) for leaks, repair leaks throughout whole unit 3. Inspect and Repair (if necessary) Drain, Water & Vent (Bathroom and Kitchen, toilets) Electrical: 1. Remove existing cover plates, supply and install all Switches / Receptacles and metal cover plates. 2. Remove existing raceways, supply and install new raceways throughout entire unit 2. Check Electric Service Panel for Gaps/Missing Breakers/Doors. 3. Remove existing light fixtures, supply and install LED integrated light fixtures in common areas, kitchen, living room and bathroom. 4. Install 10 yr. sealed smoke detectors in every bedroom. Must be installed on ceiling 4' (FT) away from entry door. 5. Install combination smoke / carbon monoxide detectors on 1 st and 2 nd Floor common areas Painting/Drywall Repair: 1. Supply all materials to Paint the Entire Units to Include: o Walls and ceilings shall be painted with two finish coats eggshell latex. o Kitchen and bathroom walls & ceilings, and all doors, shall receive a semi-gloss final finish coat. o Paint existing handrails on 1stand 2nd level stairways o Exterior door and frame, porch front and steps and exterior railing shall be painted (Lead Testing) including adjacent exterior doors and frame. o The Contractor shall be responsible for all drywall repairs, point-up and resulting painting required, ensuring a high-quality finish that is acceptable to the HABC Housing Management. o Paint shall be Sherwin Williams "Pro-Mar 200" in HABC Antique White color (or brand of equal color, finish, durability, etc.). o The Contractor shall follow United States Environmental Protection Agency (EPA) Lead-Based Paint Renovation, Repair and Painting (RRP) Program Rules.