Renovation of a recreation facility in Dripping Springs, Texas. Completed plans call for the renovation of a one-story above grade recreation facility.

The project involves the DSRP Event Center Roof Rehabilitation. Work generally includes cleaning and priming the existing roof, inspecting and repairing all existing roof fasteners, waterproofing all fasteners, seams, flashings, and penetrations, replacing existing fiberglass skylight panels (168) with metal R-panels, installing an exterior top of roof coating, and providing warranty options for 10 years, 15 years, and 20 years at the Dripping Springs Ranch Park. SCOPE OF WORK The work under this section of the Specifications consists of furnishing all supervision, labor, equipment, material and installation for repair and top coating of existing roof at the Dripping Springs Ranch Park Arena. Work under this section shall include all costs required for the following scope of work: a) Pressure wash entire surface of existing roof with a minimum 3,000 psi to achieve a surface free of dirt, oil, grease, loose debris, loose rust, residue or other contaminants. b) Prime rust areas with a metal primer. c) Inspect all fasteners, screws, and fastening devices. Tighten or replace loose or missing fasteners so that all metal sections are firmly held and all joining sections closed. Secure the existing edge metal with new fasteners wherever loose. d) Remove all screws at the ends of the roof along the gutter's edge, install new closures under the roof panels to block the openings under each of the ribs and refasten the roof panel ends. e) Flash in all vertical seams between each panel using a thick "butter" flashing grade coating. f) Waterproof all fasteners by encasing them in a flood coat of high viscosity elastomeric coating. g) Remove all existing skylight panels and replace with metal R-panels that match the existing metal roof panels in both profile and color so that the underneath of the roof has the same appearance. Lap both ends and set with butyl tape and fasten securely. h) Waterproof all vertical seams by applying a coat of brush grade caulk. All rake flashing and defective vertical lap seams will be stitched with 4" polyester fabric embedded in high viscosity elastomeric coating. i) Waterproof all penetrations, joints, vents, flashings, and repair areas using silicone coating. j) Remove all work-related debris and haul off-site