Renovation of an elderly care / assisted living facility in Lethbridge, Alberta. Completed plans call for the renovation of a elderly care / assisted living facility.

1. Run 1/2 " galvanized conduit from the electrical panel to the transformer group bank as per code, location proposed is within hallway drop ceilings centrally located. 2. Transformer and breakers are to be clearly tagged identifying what area/suites served. 3. Strategically run dedicated shielded low voltage 2 wire from transformer to thermostat locations, ensuring wiring is run neatly and securely tied 4. Strategically run shielded low voltage 2 wire from thermostat to associated zone valve locations, ensuring wiring is within walls or run tightly under base trim for neat clean install. 5. Upon completion of all electrical infrastructure, isolate dedicated zone and install new electric Zone valve ensuring direction of flow is noted prior to removal of pneumatic valve and matched. 6. Complete wiring connections at zone valve and thermostat using twist on wire connections or other approved styles ensuring positive tight connections are achieved throughout. 7. Open isolation valves and bleed any air entrapment and return zone valve back into service. 8. Utilizing the electric thermostat control, ensuring zone valve operates appropriately, check for leaks, upon confirmation system is leak free replace coverings. 9. a) Upon project completion test boiler water, supply and add approved chemical treatment to return system back and appropriate level. b) Decommission air compressor and air dryer completely, remove from the building and dispose of. remove electrical feed, transfer switch, electrical breaker and dispose. Remove all exposed air lines throughout mechanical room and dispose, leaving area neat and clean.