This is a service / maintenance or supply contract in Judith Gap, Montana. Contact the soliciting agency for additional information.

Contractor shall provide all labor, equipment, materials, incidentals, and traffic control necessary to produce, haul, place, roll and broom approximately 101,517 square yards of laid-in-place chip seal. The chip seal will be approximately 7.2 miles long and 24 feet wide. Contractor shall provide asphalt emulsion CHFRS-2P and Type 1 chips. Traffic control with pilot cars must be maintained until dusk or fading light each workday as determined by the Project Manager. Contractor must provide enough pilot cars to keep traffic stops to a maximum of 15 minutes. The emulsion application rate for chip seals is estimated at .45 gallons per square yard. The cover material application rate is estimated at 25 pounds per square yard. Actual application rates will be based on the chip design and the actual field adjustments. If the cover material application rate of 25 pounds per square yard is not sufficient to provide a quality job, the Project Managers will jointly determine what the new application rate should be. Contractor must furnish a water truck for dust control and wetting of chips. Arrangements must be made by the Contractor for acquiring water for wetting and sweeping. It will be the responsibility of the Contractor to determine the centerline and place reflective tabs prior to the chip seal. The Department will provide final striping. Contractor shall be responsible for all private property damage claims resulting from performance of the tasks described above. Question Submission Close Date 4/27/2022 2:00 PM MDT Designated Contract Date: Work Cannot Begin Until After: July 1, 2022 Work Is Required To Be Completed On Or Before: June 23, 2023 The Department reserves the right to increase or decrease quantities.