Renovation of a stadium in Daly City, California. Completed plans call for the renovation of a stadium.

the following public works project: Public Safety Power Shutdown (PSPS) Cow Palace Arena & Event Center Engineers Estimate: $420,000.00 The project consists of all labor, equipment, and incidental materials to install PSPS equipment to backup three areas at the facility. The Bidder is required to possess a California Contractors C-10 License that is active and in good standing at the time of the bid opening and throughout the duration of Contract. 1. Full project details are included on the project plans included in Appendix B (See Appendix B - Construction Plans), and summarized below: North Hall Main existing panel is fed by a 400A,120/208V,3Ø,4W feeder. Install new 400A ATS at North Hall with the generator docking station located on the west exterior wall of the north building. Integrate ATS and docking station into the existing hall main panel using new conductors/conduit and appropriate connections. Move existing heater circuits from existing 100A panel to existing main panel. South Hall Main existing panel is fed by a 400A,120/208V,3Ø,4W feeder. Install new 400A ATS at South Hall with generator docking station located on the west exterior wall of the South Hall building. Integrate ATS and docking station into the existing hall main panel using new conductors/conduit and appropriate connections. Move existing heater circuits from existing 100A panel to existing main panel. The Roundup Room The Round Room has Qty (4) different panels with (4) different feeders providing power to different locations within the restaurant Mount a new ATS and fused disconnect on the wall of the South Hall for each panel. Add an 800A feed from docking station, feeding fused disconnect for each one. Panel BK has a 225A 3Ph 4-Wire service. Intercept the existing feeder in Tee Bar Ceiling. Route new conduit wire for line load to new ATS in South Hall. This will be the same on Blank panel (called "BL"), which is 150A 120/208 3Ph 4- Wire. This will be the same for Panel RP which is 200A 120/208 3PH 4-Wire. This will be the same for Panel M which is 100A 120/208 3PH 4-Wire.