Site work for a transportation facility in Randolph Air Force Base, Texas. Completed plans call for site work for a transportation facility.

Remove rubber & repaint pavement markings on each end of the East & West Runways at JBSA-Randolph. Sept. 2023, Remove rubber & repaint pavement markings on the east runway , (100-ft. wide x 1,500- ft. long x2 ends) and 10-ft each side of the center line (5,400-ft. x 20'), ~410,000-sqft. Also remove rubber & repaint pavement markings on each end of west runway ( 100-ft. wide x 1,500-ft. long x 2 ends) & 10-ft each side of the center line, (5,400-ft. x 20'), ~ 410,000-sqft. March 2024,Remove rubber and repaint pavement markings on the north end of the east runway (100-ft wide x 1,500-ft long x 1 end) and 10-ft each side of the center line (6,900-ft x 20'), ~290,000-sqft. Also, remove rubber and repaint pavement markings on the north end of the west runway (100-ft wide x 1,500-ft long x 1 end) and 10-ft each side of the center line (6,900-ft x 20'), ~290,000-sqft. Repair any damaged joint seal from rubber removal, replace the concrete and concrete-to-asphalt joint seals on the east and west runway up to the hold lines, not including overruns. Use fuel and blast resistant sealant end of the runway, and warmup or holding pads.Remove rubber & repaint pavement markings on each end of the East & West Runways at JBSA-Randolph. Sept. 2023, Remove rubber & repaint pavement markings on the east runway , (100-ft. wide x 1,500- ft. long x2 ends) and 10-ft each side of the center line (5,400-ft. x 20'), ~410,000-sqft. Also remove rubber & repaint pavement markings on each end of west runway ( 100-ft. wide x 1,500-ft. long x 2 ends) & 10-ft each side of the center line, (5,400-ft. x 20'), ~ 410,000-sqft. March 2024,Remove rubber and repaint pavement markings on the north end of the east runway (100-ft wide x 1,500-ft long x 1 end) and 10-ft each side of the center line (6,900-ft x 20'), ~290,000-sqft. Also, remove rubber and repaint pavement markings on the north end of the west runway (100-ft wide x 1,500-ft long x 1 end) and 10-ft each side of the center line (6,900-ft x 20'), ~290,000-sqft. Repair any damaged joint seal from rubber removal, replace the concrete and concrete-to-asphalt joint seals on the east and west runway up to the hold lines, not including overruns. Use fuel and blast resistant sealant end of the runway, and warmup or holding pads. Points of Contact: All questions and communication pertaining to this TOPR should be addressed to, both, the following individuals, unless communicated otherwise: BRYAN YBARBO TONYA BOWLES Contract Specialist (CS) Contracting Officer (CO) bryan.ybarbo.1@us.af.mil tonya.bowles@us.af.mil Technical Questions/RFIs: Questions generated by this TOPR and/or the site visit shall be submitted using the Questions/RFIs & Answers (Q&A) template (Attachment 7). Questions/RFIs are due NLT Tuesday, 30 May 2023, at 10:00 AM (CT) and shall be sent via email to, both, the CS and CO. Between $250,000 and $500,000 *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document.