Renovation and addition to an educational facility in Woodstown, New Jersey. Completed plans call for the addition of a 1,500-square-foot educational facility; and for the renovation of a educational facility.

The Project consists of an ADDITION of the Submerged-Arc Welding Lab, (approximately. 1,500 SF) at the rear of the building directly adjacent to the existing Welding Shop and the RENOVATION of the existing HVAC Lab as follows: A) ADDITION - New Submerged-Arc Welding Lab: a. Site Work - The Project Work includes new asphalt paving at the rear of the building where the new addition is located and includes the access road from the building out to Cheyney Road. The Work also includes limited concrete pads and new parking spaces as shown on the Contract Documents. b. General Construction Work - The building addition will be masonry bearing walls with brick veneer and metal wall panels above to match the existing building. The roof structure consists of sloped steel bar joists and metal deck with a modified roof system over rigid insulation with a tie-in to the existing roof, which is currently under warranty. The finished floor of the new addition will match the floor of the existing Welding Shop. Since the existing Welding Shop will be occupied by the District during the school year, a temporary means of egress from the existing Welding Shop to the exterior MUST be installed prior to the start of construction of the new addition and MUST be coordinated with the District to be done at a time when school is not in session. All other Work (new toilet room, new lighting, etc.) in the existing Welding Shop MUST be coordinated with the District and be done when school is not in session. c. Plumbing Construction Work - The Project Work includes but not limited to all items required to construct (1) one single occupant toilet room in the existing Welding Shop as indicated on the Construction Documents. d. Mechanical Construction Work - The Project includes but not limited to all the work required to install (1) rooftop unit with ductwork and exhaust fan as indicated on the Construction Documents. e. Electrical Construction Work - The Project work includes new LED Lighting in the new addition and in the existing Welding Shop and adjacent spaces. The work also includes new Electrical Panels, Feeders, Circuits and Connections for new HVAC systems as indicated on the Contract Documents. B) RENOVATION - Existing HVAC Lab: a. General Construction Work - The Project Work includes but not limited to the removal of the existing VCT flooring and mastic down to the existing concrete substrate and prepping the existing concrete substrate to receive a new epoxy floor coating with new base per the manufacturer's recommendations. All other Work as indicated in the Contract Documents. b. Mechanical/Plumbing Construction Work - The Project work includes various pieces of equipment that is being furnished by the Owner for instructional purposes. This Contractor will be responsible to provide all appurtenances as indicated in the drawings to make the equipment operational. All other HVAC equipment associated with the building systems shall be furnished and installed by this Contractor as indicated on the Contract Documents. c. Electrical Construction Work - The Project work includes but not limited to new LED Lighting in the existing HVAC Lab and adjacent spaces. The work also includes new Electrical Panels, Feeders, Circuits and Connections for all HVAC systems & Owner furnished equipment as indicated on the Contract Documents. Questions deadline: 11/28/23 at 5:00 PM email to jminniti@garrisonarch.com