Site work and paving for a road / highway in Burton, Michigan. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Reference Number 0000344548 Question Acceptance Deadline 04/08/2024 09:30 AM EDT Questions are submitted online No, General questions may be addressed by emailing questions to Peter Wingblad at p.wingblad@burtnomi.gov. Bids Are Solicited Under a General Contract for the Following Approximate Quantities of Work: 1. 1 Ls Traffic Control 2. 111,000 Sy Seal, Single Chip 3. 111,000 Sy Micro-surface, Single Cse 4. 7.3 Mile Overband Crack Seal Local Street 5. 11.6 Lm Overband Crack Seal Major Street Buyer Preferences, Guidelines & Requirements General Requirements - Bid Deposit Required - Contractors License Required - Insurance Required Bonding Requirements - Bid Bond 5 % Each proposal submitted to the Owner shall be accompanied by a Proposal Guarantee in the form of a certified check, cashier's check, money order or bid bond in an amount not less than 5% of the total base bid. No bid shall be withdrawn after the opening of proposals without the consent of the Owner for a period of ten (10) days after the bid closing. The right is reserved by the Owner to waive any informality in bids, to reject any or all bids, or accept any bid or combination of bids, which is considered most favorable to the Owner. The Owner may also adjust any work item quantities without adjustment of the bid unit price. LOCAL STREET SUBDIVISIONS - LAPEER HEIGHTS, MAPLE LAWN, MAPLEWOOD MEADOWS, CITY GARDENS AND COUNTRY GARDENS LOCAL STREETS - RINN, CARLSON AND BRABBS. MAJOR STREET - CENTER ROAD, MAPLE AVENUE, FENTON ROAD Work shall progress as follows: -Apply HMA Crack Fill Treatment (Overband Crack Fill, Roadbed) IAW Section 502. Use material IAW section 502.02.B.2. Apply in preparation for Single course Chip Seal (Seal, Single Chip). -Allow a minimum of 7 days between HMA Crack Treatment and Chip Seal treatment. -Apply Chip Seal to the full width of the roadway IAW Section 505. -Apply in preparation for Micro-Surface (Micro-Surface, Single CSE). -Allow a minimum of 48 hours between Chip Seal treatments and MicroSurface. -Apply Micro-Surface to the full width of roadway IAW Section 504. Surface treatments are to be applied to: LAPEER HEIGHTS SUBN, as directed by the Department. MAPLE LAWN SUBN, as directed by the Department. RINN STREET, as directed by the Department. CARLSON STREET, as directed by the Department. BRABBS STREET, as directed by the Department. CITY & COUNTRY GARDENS SUBN, as directed by Department.