Renovation of an educational facility in Winkler, Manitoba. Completed plans call for the renovation of a educational facility.

1 Coordinate With Electrical, Provide and Install Dedicated 120v Circuit as Required for Control Works; Wiring Methods to Division 26 Standards. 2 Responsibility for All Control Wiring and Low-voltage Panels, Mounting and Operational Commissioning of Control Related Devices and of Loose Supplied Controls Provided by Others as Part of a Packaged Equipment Supply. Wiring Required Under This Section to Be Performed by This Section Except as 3noted Otherwise. Refer to Division 26 for Wiring Methods and Emt Conduit Systems Required by All Wiring Performed Under This Section. .4 Provide O&m Training as Noted in 21 05 01 General Provisions - Mechanical. 2 Design and Installation of Low Voltage, Automatic Controls for the Following Systems and Equipment: .1new Make-up Air Units, Mua-1 & Mua-2 2 Existing Exhaust Fans, Wef-1 & Wef-2 .3 Coordination and Commissioning of Packaged Mua Controls, Including but Not Limited to: .1 Temperature Sensors 2 Integrate All External Input and Output Signals. .4 Incorporation of New Low Voltage, Automatic Controls Into Existing Building Management Ddc System to Tie Into School Divisions Head End System, .1 Incorporate New Controls Into Existing Control System. 2 Incorporate Low Voltage Automatic Control Systems for New Equipment. .3 Modify Existing Graphic Interface to Accommodate New Systems and Equipment Including but Not Limited to New Make-up Air Units and Existing Exhaust Fans, Wef-1 & Wef-2. .4 Graphics to Display Status Points, Including but Not Limited to: 1 Existing Exhaust Fan Status and New Make-up Air Unit Supply Fan Status 2 Mua Discharge Air Temperature and Setpoint. Allow for Setpoint Override. .3 Mua Vfd Speed. 4 Mua Filter Differential Pressure and Differential Pressure Setpoint. .5 Mua Gas Heat Modulation Percentage. .6 Low Limit Temperature Sensor Setpoint. .5commissioning of All New and Existing (Where Applicable) Control Systems Including but Not Limited to the Display of Graphics, Correct Implementation of Control Sequences, Proper Response From Physical Devices, Alarms, Schedules, Seasonal Switch-overs, Etc. Contractor Will Be Required to Demonstrate on Site to the Consultant That the System Has Been Commissioned and is Operating Correctly Under All Operating Sequences. Bids Shall Be Accompanied by a Security Deposit as Follows: 1 Bid Bond in the Amount of Not Less Than Ten (10)% of the Bid Price. Or Certified Cheque in the Amount of Not Less Than 10% of the Bid Price. 2 Endorse the Bid Bond (or Certified Cheque) in the Name of the Owner as Obligee, Signed and Sealed by the Principal (Contractor) and Surety. A Performance Bond of a Company Registered to Conduct the Business of a Surety in Manitoba, in the Form Attached to the Tender Documents, in the Amount of Fifty Percent (50%); of the Contract Price; and A Labour and Materials Payment Bond of a Company Registered to Conduct the Business of Surety in Manitoba, in the Form Attached to the Tender Documents, in the Amount of Fifty Percent (50%) of the Contract Price. Question Acceptance Deadline: 2024/04/05 02:00:00 PM CDT Direct questions to the office of Alliance Engineering Services Inc, 1035 Logan Avenue, Winnipeg, MB R3E 1P6, contact Evan Burnham, P. Eng., ph (204) 774-7859, email evan@allianceengservices.com . Official bid documents must be obtained from www.merx.com and bid submissions must be done through the Merx platform.