Renovation of a water / sewer project in Bonavista, Newfoundland. Completed plans call for the renovation of a water / sewer project.

Closing Time: 2:00 PM (NT) ** Please note that there has been 2 addendum issued for this project. ** Question Acceptance Deadline 2024/07/14 02:00:00 PM NDT Manufacturers Qualifications .1 The pumps and pump station manufacturer must be ISO 9001:2008 revision certified, with scope of registration including design control and service after sales activities. 2 Upon request from the engineer, the pump station manufacturer shall prove ability to produce the station within the specified delivery schedules. Evidence of facilities, equipment and expertise shall demonstrate the manufacturer's commitment to long term customer service and product support. .3 The pump shall be tested for proper operation at rated power supply values and for electrical; and mechanical integrity prior to Shipment. The pump supplier must have adequate test facilities to at least provide a single point performance test or a complete performance curve at an accuracy of +/-1%. The level regulators should also be checked for correct operation. 4 The pump / motor assembly shall be CAS approved as one, integral unit s per CSA standard CAN/CSA-C22.2.108-M89, Liquid Pumps. Proof of the approval shall be submitted by the pump manufacturer together with the approval drawings. The approval of the motor unit shall not be acceptable. 5 The supplier grants the right of inspection of the pumping station to any authorized representative of the purchaser before shipment from the factory. If inspection is requested give 48 hours notice in advance of the testing time. 2. Pump Performance Certifications .1 Solids Handling Capability .1 All internal passages, impeller vanes, and recirculation ports shall pass a 75mm spherical solid. Smaller internal passages that create a maintenance nuisance or interfere with priming and pump performance shall not be permitted. 2 Manufacturer's Start-up Services .1 The manufacturer's technical representative shall inspect the completed installation, correct or supervise the correction of any defect or malfunction, and instruct operating personnel in the proper operation and maintenance of the equipment as described in Part 4 of this section. Official bid documents must be obtained from www.merx.com and bid submissions must be done through the Merx platform.