Site work for a civil project in Palos Heights, Illinois. Completed plans call for site work for a water / sewer project.

Tank Information: The structure is a 250,000-gallon spheroid elevated water storage tank with a low-water level of 80.25 ft. located at 8128 Misty Meadow Drive in Palos Heights, Ilinois. The work includes: Exterior: High pressure water clean (5,000 to 10,000 psi) and spot power tool clean to a SSPC-SP11 standard. Apply a three (3) coat epoxy urethane fluoropolymer system. Coating is to be applied with partial containment. Dry Interior :Spot power tool clean the spot coating failures throughout to a SSPC-SP11 standard. Apply a spot two (2) coat epoxy system to the prepared surfaces. Dry Interior Fill/Draw Pipe: Remove the insulation and spot power tool clean the spot coating failures throughout to a SSPC-SP11 standard. Apply a three (3) coat thermal break coating system to the pipe. Dry Interior Fill/Draw Pipe - Alternate: Remove the insulation and abrasive blast clean to a SSPC-SP6 commercial blast standard. Apply a three (3) coat zinc thermal break coating system to the pipe. Pit Piping: Abrasive blast clean to a SSPC-SP6 commercial standard. Apply a two (2) coat epoxy system. Foundation: Water clean and apply a two (2) coat epoxy system. Mixer: Install a mechanical mixer. Repairs: 1) Install a gasket on the bolted painter's hatch. 2) Install handholds at the access tube roof hatch. 3) Install deflector bars on the fill/draw pipe. 4) Install a mud valve. 5) Install a pressure vacuum vent. 6) Install a seal at the access tube air gap. 7) Weld steel plates over the cathodic lift holes. 8) Install roof rigging couplings. 9) Weld a rigging lug on the bowl. 10) Install insulation on the fill/ draw pipe. 11 ) Replace the expansion joint - alternate. 12) Replace the dry interior light bulbs. Question Deadline 10/08/2024 The Bidder shall submit all questions about the meaning or intent of the Bidding Documents to DIXON in writing. Contact information and submittal procedures for such questions are to be made to the Issuing Office.