Demolition, site work and renovation of a retail development in Platte City, Missouri. Completed plans call for the demolition of a retail development; for the renovation of a retail development; and for site work for a retail development.

Platte Falls CA Shop Roof Skylight Resealing & Gutter Replacement Site Address: 16800 Settle Station Road Platte City Mo Question Deadline 01/28/2025 Site Directions: Take Route HH (Platte City exit) east 0.60 mile. North side: Take the Highway 371 exit off I-29, travel northeast on Elm Grove Road about 1.50 miles, then east on Sharps Station Road 1.60 miles, and south on Settle Station Road 0.50 mile. Site mobilization/demobilization. The project scope of work shall comply with the intent of the ICC - 2018 version of the international building code (IBC) This project is intended to address the installation of gutters and downspouts to the existing pole barn structure as outlined in the diagrammatic plan. Additionally, the project will provide a vented ridge cap and flashing extension to provide waterproofing at an existing translucent roof panel. (8) 21' downspouts, (1) 12' downspout, and (1) 10' downspout will be installed as located in the plan and the existing subgrade boots will be utilized to terminate the pipe and deliver water to daylight as indicated in the drawing. Concrete splash blocks will be provided by the contractor at all other locations. The project includes the installation of a new vented ridge flashing with flashing extensions with closures to cover and waterproof the uphill edge of the translucent roof panels. Additionally, flanged snow gutters with straps and downspouts to 2 existing boot locations and the rest of the downspouts drain to splash blocks at grade. This plan is for diagrammatic location of downspouts, approximate linear footage of gutters, and quantity of downspout information purposes only. Contractor to verify precise dimensions if necessary. Install fall protection anchors as shown under ridge cap and anchor to existing purlin. Seal all penetrations for anchors prior to capping. Install permanent fall protection anchors per manufacturer instructions. Add blocking and anchor to meet the manufacturer requirements and cover with ridge vent with end closures.