Renovation of a mixed-use development in Santa Maria, California. Completed plans call for the renovation of a educational facility.

Online Q&A Yes Q&A Deadline 05/05/2025 5:00 PM (PDT) Built - Up Roof Replacement at Five District School Sites All questions regarding this solicitation shall be directed through online. Each Bid shall be accompanied by a bid security in the form of a certified check, cashier's check, or Bid Bond by a guaranty company authorized to conduct business in the State of California, in an amount equal to at least ten percent (10%) of the sum of the total amount of the bid, including any options. The successful bidder will be required to furnish a Payment Bond and Performance Bond in an amount equal to one hundred percent (100%) of the total amount of the contract before commencement of work and conforming to the contract documents. The successful bidder will be allowed to substitute securities or establish an escrow in lieu of retainage, pursuant to Public Contract Code Section 22300, and as described in the General Conditions. Each bidder is required to furnish and maintain proof of Commercial General Liability Insurance, Workers' Compensation Insurance, and all other insurance or certifications as required by the contract documents. Disabled Veteran Business Enterprises (DVBE) Participation Requirement State law and regulations adopted by the State Allocation Board (SAB) require that State-funded contracts have participation goals of 3% for Disabled Veteran Business Enterprises as defined in Public Contract Code Section 10115.1. To be considered, a FIRM is required to meet the participation goals or make a good-faith effort to meet the DVBE participation goals as outlined in the regulations. In awarding the contract, the District shall consider the firm's compliance with SAB statutes and regulations related to DVBE participation. The District reserves the right to reject any or all bids and to waive irregularities or informalities in any bid or in the bidding process. No bidder may withdraw its bid for a period of ninety (90) days after the date set for the opening of bids. Remove the existing roofing system down to wood deck Replace all dry rot Mechanically attach minimum R-10 polyiso insulation per ASCE 7-16 tapered as necessary to create positive slope to the drains with no ponding conditions. Drains are to be sumped to allow for additional drainage Adhere 1/2 Inch Densdeck prime coverboard attached with Insul-Lock foam adhesive Install one ply Flexbase Plus 80 set in GreenLock adhesive applied at a minimum 2.5 gal/100sf Install one ply KEE-Stone FB 60 set in KEE-Lock spatter spray foam adhesive applied at 1800sqft per kit Install new R-Mer Edge coping on all parapet walls Replace all drains with new Viking drains and screens with screens painted blue Termination bar to be applied on all flashings set in butyl tape and sealed with Tuff Stuff sealant All curbs to meet a minimum of 6-8Inch height Contractor is responsible to ensure positive drainage and no ponding conditions All exposed ducts to be sealed at the joints with 6Inch Unibond ST tape and completely coated with Cool-Sil coating at 2.5 gallons per 100SF All gutters and leaderheads to be replaced with new 22GA Garland flat sheet in style selected by the owner from the manufacturers standard and designer list of colors All downspouts to be replaced with schedule 30 pipe welded and secured properly according to the approved engineered drainage calculations and SMACNA standards All conduit to be properly supported on Viking C-Port supports 3' wide path of travel to be approved by the owner with Viking KEE walkway pads leading to and around all rooftop mechanical equipment Replace all non-mechanical rooftop air vents, heat stacks, breathers, and penetration flashings to match the existing. All penetrations are to be appropriately sealed and booted per Garland-approved details