Site work for a water / sewer project in Guadalupe, Arizona. Completed plans call for site work for a water / sewer project.

BID ADVERTISEMENT FOR THE TOWN OF GUADALUPE The Town of Guadalupe will be accepting bids from eligible contractors for the following: WASTEWATER COLLECTION SYSTEM REHABILITATION FY 2023 GRANT NO: B-23-CPAZ-0044 TOWN OF GUADALUPE 9241 S. AVENIDA DEL YAQUI (Town Hall) GUADALUPE, AZ 85283 PROJECT DESCRIPTION: The project will include the removal and replacement of 120 linear feet of 8-inch diameter sanitary sewer pipe, installation of 3,244 linear feet of 8-inch, and 194 linear feet of 18-inch Cured-In Place-Pipe (CIPP) liner, remove and replace twelve (12) manhole frame and covers, and install two (2) concrete manholes as indicated in the Construction Documents. Dibble is serving as the Town's consultant on this project. The Town of Guadalupe will endeavor to insure in every way possible that disadvantaged/minority/women-owned business enterprises and qualified businesses shall have every opportunity to participate in providing professional services, goods and construction contracts without being discriminated against on the grounds of race, religion, sex age or natural origin. A. The Contractor shall comply with all Federal, State, and local rules and regulations related to environmental protection and environmental safety including, but not limited to, the following: 1. Title 29 Code of Federal Regulations Part 1910, Occupational Safety and Health 2. Title 40 Code of Federal Regulations, Protection of Environment 3. Title 49 Code of Federal Regulations, Transportation 4. State Occupational Safety and Health Administration (OSHA) 5. Arizona Department of Environmental Quality (ADEQ) 6. Arizona Department of Water Resources (ADWR) 7. Maricopa County Air Pollution Control Regulations 8. Maricopa County Air Quality Department Regulations B. In order to ensure the Town that the Contractor is complying with the intent of the regulations stated in Paragraph 1.01.A above, as they relate to the on-site use of hazardous materials, hazardous wastes and other substances similarly defined in those regulations, develop and maintain a Contractoris Hazardous Materials Management Program that includes as a minimum, but is not limited to the requirements specified herein. The interests of the Town are that accidental spills, site contamination, and injury of personnel on the site are avoided. The Town will not enforce suspected violations of the rules and regulations referenced in Paragraph 1.01.A above, however the Town will notify the Contractor of suspected violations. If in the opinion of the Town, the Contractor fails to address the suspected violations in a timely and appropriate manner, the Town will notify Federal, State, or local regulatory agencies, report the suspected violations to them, and request that they inspect the Contractoris operations. Any fines that may be levied against the Town for violations committed on the site by the Contractor, as well as any costs to the Town associated with cleanup of materials, shall be reimbursed immediately by the Contractor. All documents required by the program shall be made available to the Townis Representative immediately, upon request. C. Responsibility for any hazardous waste, as defined in any of the above-listed regulations, and those generated by the Contractor, belongs to the Contractor. If the Contractor is going to generate, or has generated, a substance that qualifies as a hazardous waste, the Contractor must obtain an EPA identification number, listing the Contractoris name and construction site address as the generator of the hazardous waste. Responsibility for the identification, analysis, profiling, transport and disposal of hazardous wastes generated, belongs to the Contractor. The identification number can be obtained from the Arizona Department of Environmental Quality (ADEQ). This number shall be provided to the Townis Representative within five (5) days after the Notice to Proceed, or before any hazardous materials are brought onto the site. This Technical Specifications section specifies requirements and procedures for the Contractor in preparing schedules. The purpose of the schedule shall be to ensure adequate planning and execution of the work by the Contractor, notification and coordination of construction activities with the general public, to establish the standard against which satisfactory completion of the project shall be judged, to assist the Town or Townis Representative in monitoring progress and for the assessment of the impact of change orders on the Schedule. This section specifies digital color photographs and digital video recordings to be taken at the ground surface level by the Contractor before and after construction commences for the rehabilitation of sanitary sewer pipes and access manholes located in Town Right-of-Way or Utility Easements. These recordings shall clearly document site conditions prior to construction activities commencing and again following the completion of construction activities. A. SCOPE: This Technical Specifications Section describes requirements for temporary bypassing and dewatering of sewers during sanitary sewer pipe and access manhole rehabilitation, if required. SCOPE This Technical Specifications Section specifies the Cured-In-Place-Pipe (CIPP) rehabilitation lining, sets acceptable material and experience parameters, defines minimum performance requirements for the finished, installed product and details testing requirements for the completed product. This Technical Specifications section specifies the requirements for cleaning of the sewer pipe, manholes, and sewer structures prior to remote visual inspection, Townis Representative inspection, and pipe, manhole, or sewer structure repair. The work to be done under this Contract consists of furnishing all labor, materials, and equipment to remove the accumulated sediments and clean the sanitary sewers as indicated on the Design Drawings.