Site work and new construction of a playground / park / athletic field in Kearney, Nebraska. Completed plans call for the construction of a two-story above grade playground / park / athletic field; and for site work for a playground / park / athletic field.

A contract to provide a new two-story 8 x18 press If you have any questions regarding this Request for Proposals, please contact Eric Hellfire at Halliwell@kearneygov.org. The City of Kearney reserves the right to reject any and all proposals and to accept the proposals it believes is in the best interest of the community. ALL QUESTIONS MUST BE SUMMITTED BY EMAIL TO THE FOLLOWING PERSON: Eric Hellriegel, Director of Parks ehellrieQel@keameYqov.org The City of Kearney, Nebraska is requesting proposals from press box vendors in order to establish a contract to provide a new two-story 8'x18' press box at Dryden Park, 701 East 31st Street, Kearney, Nebraska. The City of Kearney is an equal opportunity employer and requires all contractors and consultants to comply with all applicable federal and state laws and regulations. Scope of Work The proposal will include material, labor and equipment to manufacture, deliver and install a two-story press box onsite at Dryden Park. Vendor shall work with City staff to keep disruption of park grounds to a minimum. Vendor will work with the City of Kearney to determine sufficient staging areas, if necessary. Construction window will be from December 1, 2025 to March 15, 2026. Project must be substantially complete by March 15, 2026. Specifications Manufacturer has ten years experience in manufacturing modular press boxes. Provide a manufacturer's warranty of five years on structural components and exterior finishes. Press Box should be two story with unfinished storage on main floor and finshed on second level. Fabricate factory built, prefabricated structures for crane unloading under base or welded in place concealed lifting lugs at roof that are suitable for placemenet of the structure on prepared foundation. Standalone stair system to grade for press box entry, gavanized steel or aluminum is permitted. Exterior Swinging Doors should be commercial grade steel type with lockable hardware. Press Box windows should be horizontal sliding with insect screen and locking device. Press box dimension is 8-foot wide by 18-foot long. Electrical Power Service should be provided with NEC Standards. Press box shall be of open construction, allowing inspection of wiring, switches and other components. Finished floor should be either commercial grade vinyl tile or raised disc rubber tile. An 125 amp, 120/240VAC single-phase, 3-wire service with 8-16 circuit breaker panel. Provide 1120-V GFCI duplex receptacle every 8 feet. Provide indoor lighting at 50 foot-candles. Outdoor lighting should be provided to illuminate the exterior staircase and landing. Provide 9,900 btu, 110V thru-wall air conditioning. Provide full length scorer's table 18"-24" deep. Includes costs for freight, assembly and installation