Renovation of a municipal facility in Monroe, Michigan. Working plans call for the renovation of a municipal facility.

**As of February 26th,2026 bids were canceled. No definite date for the rebid.** Reference Number 0000408341 The Suburban Mobility Authority for Regional Transportation (SMART) is soliciting competitive quotes from qualified vendors for a Waste Oil Heater Replacement for the Lake Erie Transit Commission. The selected contractor shall be responsible for furnishing all labor, materials, equipment, and supervision necessary to carry out the removal and proper disposal of the existing unit, as well as the complete installation of the new equipment in accordance with all applicable codes and standards. Additionally, the contractor shall be responsible for obtaining all required permits, performing system startup and testing to ensure proper functionality. The contractor shall also provide training to designated staff on the operation and basic maintenance of the newly installed system. Please submit all warranty information with your quote. Replacement of waste oil heater for Lake Erie Transit Commission Project Location: Lake Erie Transit Commission 6150 Front Street Monroe, Michigan 48161 Please see the specifications listed below: o Heating area (sq.ft) to 10,000 o Heat range (BTUH) to 300,000 o Power supply (AC) 120v.60 Hz 20 AMPS o Unit Dimensions (H-W-D) 36" (inch) X46" (inch)x48" (inch) to be mounted on top of 8'(foot) high brackets attached to oil tank o Weigh (lbs) 630 o Chimney Location: Top for through the roof Chimney o Compressed Air: 2 CFM-18 PSI o 8" (inch) thru-roof Class A Chimney kit (16'(foot) eave) o .1 Chimney cap o .1 Storm collar o .1 24" (inch) class A chimney pipe o .1 capped cleanout Tee 8" (inch) o .1 8" (inch) barometric damper o .1 roof flashing 0/12-6/12 o .1 36" (inch) Class A chimney pipe o .1 finishing collar o .1 14" (inch) slip connector o .1 24" (inch) black pipe o .1 black tee pipe w/cap o .1 roof support bracket o .1 215-gallon tank (stores 215 gallons of waste oil) The primary and secondary air regulators, fuel line, oil bypass regulator, pump, primary strainer, in-tank check valve and oil strainer shall be installed in full compliance with the manufacturer's installation manual. The installed system must meet or exceed the performance and functional standards of the Lanair XT-300 waste oil heater or approved equal (see Section 2.04). Buyer Preferences, Guidelines & Requirements General Requirements - Federally Funded - Installation Required - Insurance Required - Warranty Information Required Award Requirements - All or None Award Question Deadline 01/20/2026 at 3:00 PM ET Questions are submitted online No