Renovation of an educational facility in Raleigh, North Carolina. Completed plans call for the renovation of a 86,500-square-foot educational facility.

Construction of and for roof recover of South Campus Building E at Wake Technical Community College. Complete plans and specifications can be obtained from Raymond Global, Inc. Electronic documents are provided at no cost. Sealed proposals will be received at Wake Technical Community College up to the specified closing date and time. Detailed information on bid submittal requirements are indicated in the bid documents. Wake Technical Community College encourages participation by MWBE firms and supports efforts to ensure and promote opportunities for minority businesses. Work Covered by Contract Documents: 1.1.1 The building will remain occupied during work. The contractor is responsible for taking all precautions necessary to protect the building, contents, and personnel from damage or injury from his operations, and from water entry into the building during construction. 1.1.2 Work under this Contract consists of furnishing all labor, materials, and equipment necessary to perform the Roof Recover of South Campus Building E. The work will include, but is not necessarily limited to, the following: 1.1.3 Building E: 1.1.3.1 Water test all roof drains prior to any work and report any blockages or other impediments to drainage to Owner and Designer, submit pre-work water test results to Designer for record. 1.1.3.2 Water test all roof drains prior to Final Acceptance and report any blockages or other impediments to drainage to Owner and Designer. Contractor to provide all work and testing required to ensure that drains operate equal to or better than pre-work water test results. Submit final water test results for record. 1.1.3.3 Remove and discard, membrane flashing, sheet metal and gravel-edge metal. 1.1.3.4 Prepare roof areas for recover system. 1.1.3.5 Remove and replace areas of deteriorated wood nailers (Unit Price #1). 1.1.3.6 Install new mechanically attached 1/2” (1 layer) gypsum coverboard. 1.1.3.7 Install new adhered TPO single-ply membrane (base bid), PVC single-ply membrane (Alternate 1). 1.1.3.8 Install new membrane flashings and metal flashings, as specified herein. 1.1.3.9 Install new sheet metal and gravel-edge metal as specified herein. Color and size shall match existing. 1.1.3.10 Furnish and install new walk pads as indicated on the Drawings. 1.1.3.11 Furnish and install new roof hatch and hatch railing system. 1.1.3.12 Installation of new fall protection railing system. 1.1.3.13 Furnish and install any miscellaneous items not specifically listed here.