Renovation of a military facility in Camp Lejeune, North Carolina. Completed plans call for the renovation of a military facility.

Only General MACC Contractors listed on the General Requirements cover page may submit a proposal for this ROICC Camp Lejeune area of responsibility project. See attached documents for scope of work and any applicable drawings. Estimated Cost Range: Between $1,000,000 and $5,000,000 Requests for Information (RFIs): RFIs must be submitted by the prime contractor to tony.d.benson.civ@us.navy.mil. The cut off for RFIs is 5/13/2026 by 2:00 PM EST in order to process all inquiries by the proposal due date. *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. roject Information The Walker Group Architecture, Inc. was contracted by NRW Engineering to conduct an asbestos sampling survey for outdoor firing range SAS189A. The specified structure is slated for repairs to replace the exterior baffle system. An asbestos survey has been requested prior to disturbance of any potential asbestos containing materials (ACM). Scope of Services A. The survey was performed on 02/04/26 by Christopher B. Walker (NC Accredited Inspector #12878, expires June, 2026). The sampling was conducted in general accordance with the U.S. Environmental Protection Agency (EPA) requirements as defined in the asbestos Hazards Emergency Response Act (40 CFR Part 763) guidelines (AHERA) and in general accordance with the North Carolina Health Hazards Control Unit (NCHHCU). B. The survey was conducted to identify the presence of asbestos containing materials (ACM) prior to repairs to the building. C. The building was assessed to determine homogenous areas (groups of materials appearing to have been installed in the same general time period and uniform in color and texture). D. As per AHERA, sufficient samples were collected from random locations of each homogenous area, with the number of samples based on the following criteria: a. Thermal Insulation Materials (piping, breeching, boiler insulation, etc.) - A minimum of (3) samples are required. Patch areas (less than 6 square or liner feet) may have (2) sample collected. b. Surfacing Materials (plaster, fireproofing, etc.) - A minimum of (7) samples are to be taken for areas greater than 5,000 square feet, five (5) samples for areas greater than 1,000 square feet, but less than 5,000 square feet, three (3) samples for areas less than 1,000 square feet, two (2) samples for patching materials. c. Miscellaneous Materials (flooring, adhesives, roofing, wallboard, etc.) - A minimum of (2) samples are required. If any one sample of a material from a homogenous area is found to be positive, then that material is considered positive, regardless of results of other samples of that material, within that area.