Site work for a development in Offutt, Kentucky. Completed plans call for site work for a development.

The Methane Emission Reduction Program (MERP) Project Description: MERP 7 - JOHNSON COUNTY. This package includes reclamation of sites in Johnson County. Vendors are encouraged to submit written questions pursuant to Section 10.9 of this RFP. Written questions shall be submitted to the Commonwealth Buyer via email at kristi.sharp@ky.gov Please reference the RFP number in the Subject Line in your email Question Deadline 05/11/2026 at 4:00 PM ET EASTERN KY-BIG SANDY GAS FIELD (Bell, Boyd, Breathitt, Clay, Floyd, Greenup, Harlan, Jackson, Johnson, Knott, Knox, Laurel, Lawrence, Leslie, Letcher, Magoffin, Martin, McCreary, Owsley, Perry, Pike, Whitley) Wells with TD at 1500' or shallower o Confer with Division Inspector, assure landowner access is approved o Construct access road to well o Dig pit and line with 6 mil liner o Remove brush from location o If tubing & rods remain in well, extract same from the hole and trip out o Any free casing (annulus not cemented) shall be removed. If no records are available to determine Top of Cement (TOC), a bond log may be required, and or perforations o Move In, Rig up and run in well with tools to determine or establish TD o Trip in hole w/tubing to TD o If casing is not cemented or unknown; perforate casing from 600' to 100'; (50' increments) o Circulate Class A, Class L, or Type 1L cement to Surface, plug solid o Cut off all casing 3 ft. below Surface the next day to ensure no fall back has occurred o Monitor cement level and top off as needed o Remove fluids from pit, properly dispose of same, and backfill pit o Properly grade, stabilize, and fully reclaim wellsite as outlined in Scope of Work Wells deeper than 1500' o Confer with Division Inspector, assure landowner access is approved o Construct access road to well o Dig pit and line with 6 mil liner o Remove brush from location, rig-up service rig o If tubing & rods remain in well, extract same from the hole and trip out o Any free casing (annulus not cemented) shall be removed. If no records are available to determine Top of Cement (TOC), a bond log may be required/ and or perforations o Run in well with tools to check/establish TD o Load well with minimum 5 barrels of 6% Gel, not to exceed 25 barrels o Trip in well w/ tubing to TD, Pump 200' Class A or Class L cement plug o Pull up above TOC , wash out, tag bottom plug o Pump fluid 6% gel/water spacer o Spot Class A, Class L, or Type 1L cement plug 50' below deepest perforation to 50' above shallowest perforation (or production zones if open hole), across any and all perforations (or production zones in open hole) not covered by bottom plug o Pump fluid 6% gel/water spacer o If casing is not cemented or unknown; perforate casing from 600' to 100'; (50' increments) o Pump surface plug from Surface Casing shoe (or, if casing shoe depth is unknown or not present, deepest freshwater depth assigned by KYDOG) to surface to isolate coal seams and fresh water zones o Monitor cement level and top off as needed o Cut off all casing 3 ft. below surface the next day to ensure no fall back has occurred o Remove fluids from pit, properly dispose of same, and backfill pit o Properly grade, stabilize, and fully reclaim wellsite as outlined in Scope of Work