Renovation of a municipal facility in Hebron, Connecticut. Completed plans call for the renovation of a municipal facility.

The Project primarily consists of remediation activities and capping of portions of the site. Bids will be received for a single prime Contract. Bids shall be on a lump sum and unit price basis as indicated in the Bid Form. Bids must be accompanied by a Bid Bond in the amount of five percent of the Bid. The successful Bidder will be required to provide Performance and Payment Bonds each in the amount of one hundred percent of the Contract Price. The project is funded by the State of Connecticut. The successful Bidder shall comply with the requirements of Prevailing Wage Rate Laws in accordance with Section 31-53 of the Connecticut General Statutes. This contract is subject to state contract compliance requirements, including nondiscrimination statutes and spending allocation goals. There is $ 368,280 in state-funding for this project. State law requires project-specific goals be set for this project based on the project's needs and available Small Business Enterprises ("SBEs") and Minority Business Enterprises ("MBEs"). The SBE goal for this project is 9.26%. The MBE goal for this project is 5.56%. The selected contractor must demonstrate good faith effort to meet the spending allocation goals. Unless provided for by the Instructions to Bidders, no Bid may be withdrawn until sixty (60) days after the Bid Opening. The Town reserves the right to: reject any or all Bids; waive informalities or defects in Bids; make extensions to review Bids; and accept the Bid(s) that, in the Town's judgment, will be in its best interests. An Affirmative Action/Equal Opportunity Employer. Minority/Women's Business Enterprises are encouraged to apply. This contract is subject to state spending allocation goals and contract compliance requirements. Q & A Deadline 09/23/2026 04:00 PM EDT Bidder shall submit all questions about the meaning or intent of the Bidding Documents to Engineer in writing. Contact information and submittal procedures for such questions are as follows: A. Submit questions via the Question and Answer section of the Project's bidding service webpage. Interpretations or clarifications considered necessary by Engineer in response to such questions will be issued by Addenda delivered to all registered plan holders. Questions received less than seven days